Kohler Iron Works Tellieur K-727-2A Kurulum Kılavuzu - Sayfa 5
Küvetler Kohler Iron Works Tellieur K-727-2A için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Kohler Iron Works Tellieur K-727-2A 25 sayfaları. Freestanding cast iron bath
Sayfayı Yazdır
Outrigger
Short
Cam
Direction of
Arrow
Bath
Wooden Bath Support Foot
Stud
(Installed at Factory)
4. Install the Wood Surround Outriggers
Press the short cams into the large holes in the four outriggers. Make sure the cam heads are flush
with or slightly below the surface of the wood.
Use a phillips screwdriver or the hex wrench provided to turn the cams so the arrows face the ends
of the outriggers.
Wet the stud threads, and use a phillips screwdriver to thread the four studs into the small holes in
the wooden legs.
Securely tighten the screws. Do not overtighten.
Turn the outrigger levelers fully clockwise.
Read the removable labels on the outriggers to determine the correct installation location of the
outriggers.
Turn the outriggers sideways, and press them onto the studs. Pivot the outriggers into the vertical
position. You may need to raise the bath slightly to get the outriggers into position.
Use a phillips screwdriver or the hex wrench provided to turn the cams 1/2 turn clockwise to
secure the outriggers to the leg assemblies.
Turn the outrigger levelers until they make contact with the finished floor.
Kohler Co.
Back End-
Left
Front End-
Left
Outrigger
Leveler
Back End-
Right
Front End-
Right
Drain Hole
5
Bath
Outrigger
Stud
Wooden Bath
Outrigger
Support Foot
(Installed
at Factory)
Cam
1007292-2-B