Kohler ADAIR K-8947T-S Kurulum Talimatları Kılavuzu - Sayfa 6

Tuvaletler Kohler ADAIR K-8947T-S için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler ADAIR K-8947T-S 10 sayfaları.

Apply caulk around base.

TO CONNECT WATER

SUPPLY

* Flexible hose (not provided) are

recommended to connect the supply

line to the fill valve. If you use a rigid

connection(not provided), take care

not to apply side forces to the bottom

of the fill valve. Be sure the rigid

connection must be fit with supply line

completely to prevent damage shank

by forced connection.

IMPORTANT:

Before turning on the supply valve for the first

time, follow the steps below to clear sand, debris and rust

from the system:

Make sure water sure water supply is off. Remove valve END

by rotating it 1/8 turn counterclockwise.

While holding a container over the uncapped VALVE to

prevent splashing, turn water supply on and off a few times.

Leave water supply off.

Replace END by engaging lugs and rotating 1/8 turn

clockwise.

Make certain the top is turned to the locked

position. Valve may not turn on if top is not fully in the

locked position.

Turn on water supply. Check that water level is at the marked

water line.

Install the tank lid and the seat. Use

the supplied hardware pack for seat.

Periodically check for leaks for several

days following the installation.

1285052-T01-A

Fig.#11

Supply Shank*

Supply Shut-Off Valve

Fig.#12

Fig.#13

-6-

(

)

1/8

)