Kohler ESCALE K-23136T-CPS Kurulum Talimatları Kılavuzu - Sayfa 32
Tuvaletler Kohler ESCALE K-23136T-CPS için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler ESCALE K-23136T-CPS 45 sayfaları.
Sayfayı Yazdır
Second method: Installation for In-Wall Tank without frame
安装方式二：无框架入墙式隐藏水箱座便器安装
2A� Installation of In-Wall Tank
2A. 隐藏水箱安装
One. Installation of In-Wall Tank on a solid wall
一 . 在实心承重墙上隐藏水箱的安装
1. Install Z-connecting plate onto tank
1. Z 连接板安装
Fasten screw with washer to fixate Z-connecting plate onto
tank.
用螺丝及垫片组合件将 Z 连接板固定在水箱上。
2. Install tank onto the wall
2. 固定水箱
A. Check the height of h1 inlet hole and h2 drainage hole
according to the dimensions of the bowl.
A. 如图首先根据座便器的进水口 h1 和排污口高度 h2 确定水
箱进水口的高度 h1 和排污管的高度 h2。
B. Align the tank on the wall as shown and locate the
installation holes of Z-connecting plate. Mark on the wall
for appropriate position for the Z-connecting plate, and
drill four holes with a diameter of 12mm and a depth of
65mm with churn drilling as shown in illustration, and fill
in the holes with expanding bolt caps.
B. 水箱靠在墙上，在墙壁上把 Z 连接板安装孔做记号后，用
冲击钻钻四个 12mm 深 65mm 的小孔，然后安装膨胀螺
丝套。
C. As shown, tighten the screw and washer to fixate the
tank.
C. 如图用 4 颗螺丝及垫片将水箱固定。
1456149-K2-A
h
Outlet Pipe
冲水管
h
Outlet Pipe
冲水管
-25-
Z-Connecting Plate
Z 连接板
Screw With Washer
螺丝及垫片组合件
Inlet Hole
Drainage Hole
进水口
排污口
h1
Finished
h2
Floor
完工地面
Expanding
Bolt Cap
Z-Connecting
膨胀螺丝套
Plate
Z 连接板
Washer
垫片
Screw
螺丝