Kohler FAMILY CARE S-TRAP K-23191T-NS Kurulum Talimatları Kılavuzu - Sayfa 9

Tuvaletler Kohler FAMILY CARE S-TRAP K-23191T-NS için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler FAMILY CARE S-TRAP K-23191T-NS 10 sayfaları. 3.0/4.8l vitreous china two piece toilet

Sayfayı Yazdır

FITTINGS AND RELATIVE POSITION IN

TANK

Caution:

Restore the moved or removed parts according to the

positions and directions as shown.

Pay attention to the position and angle of the float canister to

avoid interfere with the steel wire on the box.

For K-23191T-ITNS/K-23192T-ITNS

K-23191T-ITNS/K-23192T-ITNS

Fill Valve

Flush Valve

Float Canister

Steel Wire

Fig.#25

SYMPTOMS

1. Poor Flush

2. No Flush

3. The fill valve turns on/off by itself

without the toilet being flushed, or it

runs allowing water to enter the tank.

4. Tank takes excessive time to fill.

5. There is excessive noise when the

tank is filling.

IMPORTANT: Use only genuine Kohler parts as shown to avoid property damage.

1402301-T01-B

Push Button

Continuous Clean Assy

Button Box

CORRECTIVE ACTION

A. Adjust the tank water level to match the waterline.

B. Fully open the water supply shut-off valve.

C. Clear obstructions from the trapway, jet, or bowl rim holes.

D. Clear obstructions from the waste line.

A. Reconnect the chain to the trip lever or flush valve.

B. Adjust the chain assembly to remove excessive slack.

A. Adjust the chain for proper slack so the seal is not held off the flush valve seat.

B. Clean or replace the seal if it is worn, dirty, or misaligned with the flush valve seat, or

if the flush valve seat is damaged. Replace the flush valve seal or flush valve.

C. Clean the fill valve seat/seat washer of debris, or replace the piston/seat washer

assembly.

D. Remove the tank and tighten the flush valve nut if flush valve gasket is leaking. Do

not overtighten. If leakage continues, replace the gasket.

E. Adjust the tank water level if it is too high.

A. Fully open the water supply shut-off valve.

B. Clean the valve inlet, valve head, or supply line. Flush the lines.

A. Partially close the water supply shut-off valve if the water pressure to the toilet is too

high. Check the toilet performance following any such adjustment.

B. Remove dirt or obstructions from the valve head. Flush the lines.

For K-23191T-NS/K-23192T-NS