Kohler 5E Operasyon - Sayfa 9
Motor Kohler 5E için çevrimiçi göz atın veya pdf Operasyon indirin. Kohler 5E 48 sayfaları. Marine generator sets
Sayfayı Yazdır
WARNING
Rotating parts.
Can cause severe injury or death.
Operate the generator set only when
all guards, screens, and covers are in
place.
WARNING
Airborne particles.
Can
cause
severe
blindness.
Wear protective goggles and clothing
when using power tools, hand tools,
or compressed air.
Tightening the hardware.
projectiles can cause severe injury
or death. Loose hardware can cause
the hardware or pulley to release from
the generator set engine and can cause
personal
injury.
Retorque
crankshaft and rotor hardware after
servicing. Do not loosen the crankshaft
hardware or rotor thrubolt when making
adjustments or servicing the generator
set. Rotate the crankshaft manually in
a clockwise direction only. Turning the
crankshaft
bolt
or
rotor
counterclockwise
can
loosen
hardware.
TP-5985 10/02
Servicing the generator set when it
is operating. Exposed moving parts
can cause severe injury or death.
Keep hands, feet, hair, clothing, and
test leads away from the belts and
pulleys when the generator set is
running. Replace guards, screens, and
covers before operating the generator
set.
Sound shield removal.
moving parts can cause severe
injury or death. The generator set
must be operating in order to perform
some
procedures. Be especially careful if the
sound shield has been removed,
leaving the belts and pulleys exposed.
(Sound-shield-equipped models only)
Notice
injury
or
This generator set has been
rewired from its nameplate voltage
to
Flying
all
Voltage reconnection. Affix a notice
to the generator set after reconnecting
the set to a voltage different from the
voltage on the nameplate.
voltage reconnection decal 246242
from
thrubolt
distributor/dealer.
the
Exposed
scheduled
maintenance
NOTICE
246242
NOTICE
Order
an
authorized
service
NOTICE
Hardware damage. The engine and
generator set may use both American
Standard and metric hardware. Use
the correct size tools to prevent
rounding of the bolt heads and nuts.
NOTICE
When replacing hardware, do not
substitute
with
inferior
hardware.
Screws and nuts are
available in different hardness ratings.
To
indicate
hardness,
Standard hardware uses a series of
markings, and metric hardware uses a
numeric system. Check the markings
on the bolt heads and nuts for
identification.
NOTICE
Fuse replacement.
Replace fuses
with fuses of the same ampere rating
and type (for example: 3AB or 314,
ceramic).
Do not substitute clear
glass-type fuses for ceramic fuses.
Refer to the wiring diagram when the
ampere
rating
is
unknown
questionable.
NOTICE
Saltwater damage. Saltwater quickly
deteriorates metals. Wipe up saltwater
on and around the generator set and
remove salt deposits from metal
surfaces.
Safety Precautions and Instructions
grade
American
or
V