Kohler Aegis LV625 Kullanıcı El Kitabı - Sayfa 5

Motor Kohler Aegis LV625 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Kohler Aegis LV625 21 sayfaları. Kohler liquid-cooled vertical crankshaft owner's manual

Sayfayı Yazdır

Do not use gasoline left over from the previous season,

to minimize gum deposits in your fuel system and to

ensure easy starting.

Do not add oil to the gasoline. Do not overfill the fuel

tank. Leave room for the fuel to expand.

Fuel Type

For best results use only clean, fresh, unleaded

gasoline with the pump sticker octane rating of 87 or

higher. In countries using the Research method, it

should be 90 octane minimum.

Unleaded gasoline is recommended as it leaves less

combustion chamber deposits. Leaded gasoline may

be used in areas where unleaded is not available and

exhaust emissions are not regulated. Be aware

however, that the cylinder heads may require more

frequent service.

Gasoline/Alcohol blends

Gasohol (up to 10% ethyl alcohol, 90% unleaded

gasoline by volume) is approved as a fuel for Kohler

engines. Other gasoline/alcohol blends are not

approved.

Gasoline/Ether blends

Methyl Tertiary Butyl Ether (MTBE) and unleaded

gasoline blends (up to a maximum of 15% MTBE by

volume) are approved as a fuel for Kohler engines.

Other gasoline/ether blends are not approved.

Coolant Recommendations

Use equal parts of ethylene glycol (anti-freeze) and

water only. Distilled or deionized water is

recommended, especially in areas where the water

contains a high mineral content. Propylene glycol

based anti-freeze is not recommended.

This mixture will provide protection from -37°C (-34°F)

to 108°C (226°F). For protection and use outside the

indicated temperature limits, follow the anti-freeze

manufacturers instructions on the container, but do not

exceed 70% anti-freeze.

DO NOT use anti-freeze with stop-leak additive(s), or

put any other additives in the cooling system.

Engine Identification Numbers

When ordering parts, or in any communication

involving an engine, always give the Model,

Specification, and Serial Numbers of the engine.

The engine identification numbers appear on a decal

affixed to the engine blower housing. Include letter

suffixes, if there are any.

Record your engine identification numbers on the

identification label (Figure 4) for future reference.

IMPORTANT ENGINE INFORMATION

THIS ENGINE MEETS U.S. EPA AND CA 2005

AND LATER AND EC STAGE II (SN:4) EMISSION

REGS FOR SI SMALL OFF–ROAD ENGINES

FAMILY

TYPE APP

DISPL. (CC)

MODEL NO.

SPEC. NO.

SERIAL NO.

BUILD DATE

OEM PROD. NO.

EMISSION COMPLIANCE PERIOD:

EPA:

CARB:

CERTIFIED ON:

REFER TO OWNER'S MANUAL FOR HP RATING,

SAFETY, MAINTENANCE AND ADJUSTMENTS

1-800-544-2444 www.kohlerengines.com

KOHLER CO. KOHLER, WISCONSIN USA

Figure 4. Engine Identification Label.

The Emission Compliance Period referred to on the

Emission Control or Air Index label indicates the

number of operating hours for which the engine has

been shown to meet Federal and CARB emission

requirements. The following table provides the Engine

Compliance Period (in hours) associated with the

category descriptor found on the certification label.

Category C

EPA

250 Hours

Moderate

CARB

125 Hours

Emission Compliance Period (Hours)

Refer to certification label for engine displacement.

Exhaust Emission Control System for models LV625,

LV675, and LV680 is EM.

Model Designation

Model LV625 for example: L designates liquid cooled,

V designates vertical crankshaft, and 625 is the model

designation. A letter suffix designates a specific

version as follows:

Suffix

Designates

Electric Start

N11236

Category A

Category B

500 Hours

1000 Hours

Intermediate

Extended

500 Hours

250 Hours