Kohler COMMAND CH12.5 Kullanıcı El Kitabı - Sayfa 13
Motor Kohler COMMAND CH12.5 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Kohler COMMAND CH12.5 17 sayfaları. Horizontal crankshaft
![Kohler COMMAND CH12.5 Kullanıcı El Kitabı](/uploads/products/server2/2635030/2635030.jpg)
- 1. Safety Precautions
- 2. California Proposition 65 Warning
- 3. Oil Recommendations
- 4. Oil Type
- 5. Fuel Recommendations
- 6. Cold Weather Starting Hints
- 7. Maintenance Instructions
- 8. Maintenance Schedule
- 9. Change Oil and Oil Filter
- 10. Oil Sentry
- 11. Carburetor Troubleshooting and Adjustments
- 12. Troubleshooting
- 13. Specifications
- 14. Parts Ordering
- 15. Major Repair
- 16. Model Designation
Now turn the adjusting needle in (clockwise). The
engine speed may increase, then it will decrease
as the needle is turned in (lean). Note the position
of the needle.
Set the adjusting needle midway between the rich
and lean settings. See Figure 14.
Adjust to
Midpoint
Rich
Figure 14. Optimum Low Idle Fuel Setting.
Troubleshooting
When troubles occur, be sure to check the simple causes which, at first, may seem to obvious to be considered.
For example, a starting problem could be caused by an empty fuel tank. Some common causes of engine troubles
are listed in the following table.
Do not attempt to service or replace major engine components, or any items that require special timing or
adjustment procedures. Have your Kohler Engine Service Dealer do this work.
Possible Cause No
Improper
Problem
Fuel
Will Not Start
•
Hard Starting
Stops Suddenly
•
Lacks Power
Operates Erratically
Knocks or Pings
Skips or Misfires
Backfires
Overheats
High Fuel Consumption
Lean
Dirt In
Fuel
Fuel Line/SystemGrass Screen Oil Level
•
•
•
•
•
•
•
•
•
•
•
•
•
•
3. Low Idle Speed Setting: Place the throttle
control into the "idle" or "slow" position. Set the
low idle speed to 1200 RPM* (± 75 RPM) by
turning the low idle speed adjusting screw in or
out. Check the speed using a tachometer.
*NOTE: The actual low idle speed depends on the
application – refer to equipment
manufacturer's recommendations. The
recommended low idle speed for basic
engines is 1200 RPM. To ensure best
results when setting the low idle fuel
needle, the low idle speed must not
exceed 1200 RPM (± 75 RPM).
Dirty
Incorrect
Overloaded
•
•
•
•
•
•
•
•
•
•
•
Engine
Dirty Air
Cleaner
Spark Plug
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Faulty
•
•
•
•
•
•
•
•
13