Kohler KD 500 Atölye El Kitabı - Sayfa 40
Motor Kohler KD 500 için çevrimiçi göz atın veya pdf Atölye El Kitabı indirin. Kohler KD 500 44 sayfaları. 51267
15
STORAGE
Storage
Prepare engines as follows for storage over 30 days
Temporary protection (1/6 months)
• Let engine run at idling speed in no-load conditions for 15 minutes.
• Fill crankcase with protection oil MIL-1-644-P9 and let engine run at 3/4 full speed for 5/10 minutes.
• When engine is warm empty oil pan and fill with standard new oil
• Remove fuel tube and empty the tank
• Remove fuel filter, replace cartridge if dirty and refit
• Carefully clean cylinder fins, heads and fan
• Seal all openings with tape.
• Remove injectors, pour a spoonful of oil type SAE 30 into the cylinders and rotate manualy to distribute the oil. Refit injectors.
• Spray oil type SAE 10W into exhaust and intake manifolds, rocker arms, valves, tappet etc. Grease all unpainted parts.
• Loosen belt
• Wrap the engine in a plastic film.
• Store in a dry place, if possible not directly on the soil and far from high voltage electric lines.
Permanent protection (over 6 months)
• The following is recommended apart from the above instructions:
• For the lubrication and injection system as well as for moving parts use rustproof oil type MIL-L-21260 P10 grade 2, SAE 30 (Ex.
ESSO RUST - BAN 623 - AGIP, RUSTIA C. SAE 30) Let the engine run with rustproof oil and drain any excess.
• Coat external unpainted surfaces with antirust type MIL-C- 16173D - grade 3 /Ex. ESSO RUST BAN 398 - AGIP, RUSTIA 100/F).
How to prepare the engine for operation
• Clean engine outside
• Remove protections and covers
• Remove antirust with an appropriate solvent or degreaser.
• Remove injector, fill with standard oil, turn crankshaft by a few revolutions, remove oil pan and drain the protective oil.
- 40 -
Workshop Manual KD500 _ cod. ED0053029390 - 1° ed_rev. 00