Kohler 10ERG Kullanım Kılavuzu - Sayfa 8
Taşınabilir Jeneratör Kohler 10ERG için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Kohler 10ERG 48 sayfaları. Commercial mobile generator set
Sayfayı Yazdır
Welding the generator set.
cause severe electrical equipment
damage. Before welding the generator
set perform the following steps:
(1) Remove
the
battery
negative (--) lead first. (2) Disconnect
all engine electronic control module
(ECM) connectors. (3) Disconnect all
generator set controller and voltage
regulator circuit board connectors.
(4) Disconnect the engine battery-
charging
alternator
connections.
(5) Attach the weld ground connection
close to the weld location.
Short
circuits.
voltage/current can cause severe
injury or death. Short circuits can
cause bodily injury and/or equipment
damage.
Do not contact electrical
connections with tools or jewelry while
making
adjustments
or
Remove all jewelry before servicing the
equipment.
Engine block heater.
voltage can cause severe injury or
death. The engine block heater can
cause electrical shock. Remove the
engine block heater plug from the
electrical outlet before working on the
block heater electrical connections.
Electrical backfeed to the utility.
Hazardous backfeed voltage can
cause severe injury or death.
Connect the generator set to the
building/campground electrical system
only through an approved device and
after the building/campground main
switch
is
opened.
connections can cause severe injury or
death to utility personnel working on
power lines and/or personnel near the
work area. Some states and localities
prohibit unauthorized connection to the
utility electrical system.
transfer
switch
to
interconnection of the generator set
power and other sources of power.
IV Safety Precautions and Instructions
Can
Hot Parts
cables,
Hot coolant and steam.
Can cause severe injury or death.
Before removing the pressure cap,
stop the generator set and allow it to
cool. Then loosen the pressure cap
to relieve pressure.
Hazardous
repairs.
Hot engine and exhaust system.
Can cause severe injury or death.
Hazardous
Do not work on the generator set until
it cools.
Checking the coolant level.
coolant can cause severe injury or
death.
Release pressure from the cooling
system before removing the pressure
cap. To release pressure, cover the
pressure cap with a thick cloth and then
slowly turn the cap counterclockwise to
the first stop. Remove the cap after
pressure
released and the engine has cooled.
Backfeed
Check the coolant level at the tank if the
generator set has a coolant recovery
tank.
Servicing the exhaust system. Hot
parts can cause severe injury or
death. Do not touch hot engine parts.
Install a
The engine and exhaust system
prevent
components become extremely hot
during operation.
Combustible materials.
cause severe injury or death. A hot
exhaust system can ignite adjacent
combustible materials. Do not locate
electrical
combustible
exhaust muffler.
when parking your vehicle to prevent
the exhaust system and hot exhaust
gases from starting grass fires.
WARNING
WARNING
Hot
Allow the engine to cool.
has
been
completely
Fire can
wiring,
fuel
lines,
materials
above
the
Exercise caution
Combustible materials.
cause severe injury or death. A hot
generator set can ignite debris in the
compartment. Keep the compartment
and generator set clean and free of
debris and combustible materials to
minimize the possibility of fire. Do not
block the fuel/oil drain opening in the
generator set mounting tray. Cut a
corresponding hole in the subfloor, if
used, for the drain opening.
Moving Parts
WARNING
Hazardous voltage.
Can cause severe injury or death.
Operate the generator set only when
all guards and electrical enclosures
are in place.
WARNING
Rotating parts.
Can cause severe injury or death.
Operate the generator set only when
all guards, screens, and covers are in
place.
WARNING
Airborne particles.
Can
cause
severe
blindness.
Wear protective goggles and clothing
when using power tools, hand tools,
or
or compressed air.
Fire can
Moving rotor.
injury
or
TP-6334
9/04