Kohler 12RESM1 Kurulum Kılavuzu - Sayfa 13

Taşınabilir Jeneratör Kohler 12RESM1 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Kohler 12RESM1 36 sayfaları. Residential/commercial generator sets
Ayrıca Kohler 12RESM1 için: Kurulum Kılavuzu (40 sayfalar), Manuel (36 sayfalar), Kullanım Kılavuzu (48 sayfalar), Operasyon (48 sayfalar)

Sayfayı Yazdır

2.1 General

Have an authorized distributor/dealer install the

generator set outdoors according to the instructions in

this manual. The generator set installation must comply

with the National Electrical Code (NEC) and local code

requirements. Do not install this generator set indoors.

Use the specifications provided here only in the initial

planning. Use the generator set and transfer switch

spec sheets, dimension drawings, and wiring diagrams

for installation.

2.2 Lifting

WARNING

Unbalanced weight.

Improper lifting can cause severe

injury or death and equipment

damage.

Do not use lifting eyes.

Lift the generator set using lifting bars

inserted through the lifting holes on

the skid.

The generator set weighs approximately 180 kg

(400 lb.). Use lifting bars inserted through the holes in

the skid to lift the unit. See Figure 2-1 for lifting hole

locations.

TP-6397 4/07

Section 2 Installation

2.3 Generator Set Inspection

Complete a thorough inspection of the generator set.

Check for the following:

Inspect the generator set for loose or damaged parts

or wires. Repair or tighten any loose parts before

installation.

Check the engine oil. Fill, if necessary, with the

recommended viscosity and grade of oil.

synthetic oil, API (American Petroleum Institute)

Service Class SG or higher. See TP-6398, Operation

Manual, for additional information.

2.4 Location and Mounting

See Figure 2-1 for the generator set dimensions and

fuel and electric inlet locations. The drawing dimensions

are shown in millimeters, with inches in brackets. The

wiring kit is shown as packaged for shipping.

Locate the generator set outdoors. See Figure 2-2 for

the minimum clearance around the generator set.

Select a location where the generator set exhaust does

not blow on plants or other combustible materials. Do

not install the generator set where exhaust gas could

accumulate and seep inside or be drawn into a

potentially occupied building.

2.4.1

Standard Mounting

The generator set is shipped on a plastic mounting pad.

Prepare a flat, level mounting area covered with a weed

barrier and gravel as shown in Figure 2-2. Set the

plastic mounting pad directly on the gravel. Do not

install the mounting pad directly on grass.

2.4.2

High-Wind Enclosure Mounting

See Figure 2-3 for mounting details for the optional

high-wind enclosure.

Use

Section 2 Installation