Kohler KDI 1903M Kullanıcı El Kitabı - Sayfa 34
Taşınabilir Jeneratör Kohler KDI 1903M için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Kohler KDI 1903M 50 sayfaları. Diesel kdi
Ayrıca Kohler KDI 1903M için: Kullanıcı El Kitabı (38 sayfalar), Kullanıcı El Kitabı (40 sayfalar), Kullanım ve Bakım (42 sayfalar)
Sayfayı Yazdır
5
5.10 Check fuel filter cartridge
Important
• Before proceeding with operation, read
Danger
•
For safety precautions see
1. Gently loosen the water drain plug A without removing it.
2. Spill out the water if present.
3. Re-tighten the water drain plug A as soon as the fuel spills.
5.11 Product preservation
Important
• If the engines are not to be used for 6 months, they must be protected by carrying out the operations
described in Engine storage (up to 6 months)
•
If the engine is still not in use after the first 6 months, it is necessary to carry out a further operation to
extend the protection period (more than 6 months)
•
If the engine is not to be used for an extended period, the protective treatment procedure must be repeated
within 24 months of the previous one.
5.12 Engine storage (up to 6 months)
Before storing the engine check that:
•
The environments are not humid or exposed to bad weather. Cover the engine with a proper protective sheet
against dampness and atmospheric contaminants.
•
The place is not near electric panel.
•
Avoid storing the engine in direct contact with the ground.
5.13 Engine storage (over 6 months)
Follow the steps described in
1. Engine oil replacement
2. Refuel with fuel additives for long storage.
3. With expansion tank:
make sure that the coolant is up to the maximum level.
4. Without expansion tank:
Top liquid up until the pipes inside the radiator are covered by about 5 mm.
Do not overfill the radiator, but leave room for the fuel to expand.
5. Start the engine and keep it idle at minimum speed for 2 minutes.
6. Bring the engine to 3/4 of the maximum speed for 5÷10 minutes.
7. Turn off the engine.
8. Completely empty the fuel tank.
9. Spray SAE 10W-40 on the exhaust and intake manifolds.
10. Seal the exhaust and intake ducts to prevent foreign bodies from entering.
11. When cleaning the engine, if using a pressure washer or steam cleaning device, avoid directing the nozzle on
electrical components, cable connections and sealed rings (oil seals etc).
If cleaning engine with a pressure washer or steam cleaner, it is important to maintain a minimum distance of
at least 200mm between the surface to be washed and the nozzle - avoiding absolutely electrical
components such as alternators, starter motors and engine control units (ECU).
12. Treat non-painted parts with protective products.
If the engine protection is performed according to the suggestions indicated no corrosion damage should occur.
EN
34
INFORMATION ABOUT MAINTENANCE
Chap.
3.
Par.
5.12.
(Par.
6.1).
Par.
3.2.2.
(Par.
5.12).
(Par.
5.13).
Fig 5.14