Kohler Englefield VALENCIA Vanity Series Kurulum Talimatları Kılavuzu - Sayfa 4

İç Mekan Mobilyaları Kohler Englefield VALENCIA Vanity Series için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler Englefield VALENCIA Vanity Series 6 sayfaları.

Sayfayı Yazdır

VALENCIA

Vanity

2 Changing drawer trims (Optional)

NOTE: This section is only applicable if you have

purchased alternate trims for your vanity cabinet.

(a) After both drawers have been removed (refer to

section 1), unscrew the 2 trim fixing screws from

each angle bracket located behind either side of

each trim.

NOTE: Keep the screws for use later on.

Upper trim

Angle

brackets

Lower trim

(b) Unscrew 3-4 screws from underneath each

trim and remove the trims from the cabinet.

NOTE: Keep the screws for use later on.

that were removed from the original trims.

3 Water supply and waste pipe holes

(a) Measure and mark the centres for water

supply and waste pipes on the back of the

cabinet.

(b) With a suitably sized hole saw drill the holes

for the water supply and waste.

NOTE: Before fastening the cabinet make sure that

the it is sitting level and square and if installing a

Angle

brackets

floor mounted model ensure that the selected

location is free of bumps and protrusions.

NOTE: Screws should be positioned in an evenly

4 Fixing the vanity to the wall

(a) Fix the cabinet to the wall using screws (min

Alternate drain

position for floor

standing models

INSTALLATION INSTRUCTIONS

into position over the pipework.

spaced pattern as shown below.

Floor standing models

Screw positions

for 600mm floor

mount vanity shown

Wall Hung models

Screw positions

for 600mm wall

mount vanity shown

10g x 75mm) and *20mm washers. Screw

through the back rail or wall so that they screw

into the nog/s in the wall behind.

*Washers must be used to spread the load.

Number of screws required

Size

Floor Mount

600

750

900

1200

Wall Mount

ENGLEFIELD