Kohler RIVLET K-31534K-CP Kurulum Talimatları Kılavuzu - Sayfa 2
İç Mekan Mobilyaları Kohler RIVLET K-31534K-CP için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler RIVLET K-31534K-CP 8 sayfaları.
Sayfayı YazdırROUGHING-IN
Reference Value
参考值
INSTALLATION
Install Washbasin Cabinet
Install the services.
Hot (H) and Cold (C) inlets must be connected to the correct
inlet pipes.
The inlet pipe for foot basin must be connected with Cold (C)
inlet.
Install the drain in accordance with the manufacturer's
instructions.
Washbasin drain can be connected with the P-trap or S-trap
pipe. The foot basin must be drained from the floor.
NOTE: The Y-connector is optional for connecting the
washbasin and foot basin drainpipe simultaneously and
draining from the floor.
CAUTION! Make sure a watertight seal exists on all
washbasin and foot basin drain connections.
CAUTION! Provide access to the plumbing
connections for future plumbing maintenance.
The hot and cold water supplies must be installed with
isolating valves.
Refer to the following pictures, for the wall installation
positions of the faucet inlet angle valve and the floor
drain hole.
1472252-T01-C
Kohler reserves the right to change marked dimensions without prior notice.
科勒公司保留随时变更图中标示尺寸的权利，无需另行通知。
Cabinet Wall Bolt Holes
浴室柜固定墙面膨胀螺栓孔
Cabinet Outline
浴室柜外轮廓
Ground Drain Hole Set Area
建议设计地排水孔区域
尺寸图
安装
安装脸盆柜
安装管道
热水 (H) 及冷水 (C) 入口必须连接至正确的进水管。
洗脚盆进水管只能连接冷水入口。
根据制造商说明书安装排水。
脸盆可以使用墙排水或者地排水方式，洗脚盆必须使用地排水方
式。
注：采用地排水方式时，可以选购 Y 型三通地漏接头，同时将脸
盆和洗脚盆排水插入三通，再将三通插入地排排水。
小心！ 请确保所有脸盆和洗脚盆排水的连接处都装有防
水密封圈。
小心！ 管道连接处需留有检修空间，以备日后管道维护
之用。
注意！安装冷热供水管时必须使用隔离阀。
浴室龙头进水角阀的墙面安装位置和地面排水孔位置， 参考下图。
Center
安装中心线
590
440
120
350
120
795
Inlet Angle Valve Set Area
建议角阀安装区域
360
50
50
490
-2-
580
Unit: mm
单位： 毫米