a-TroniX 9885376 Kullanım Kılavuzu - Sayfa 11

Genişletici a-TroniX 9885376 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. a-TroniX 9885376 15 sayfaları.

Sayfayı Yazdır

Instruction Manual

Jump starter Booster 12V 4000A

7. Forced start for batteries with a

voltage below 6 V

This mode is recommended when starting a vehicle with a fully discharged, extremely

discharged, missing, or switched-off battery.

CAUTION:

SOME SECURITY FUNCTIONS ARE DISABLED,

PLEASE BE CAREFUL WHEN USING THE JUMPER.

Check that the jump starter is switched off.

■

Identify the vehicle's ground terminal; usually it is connected to the negative terminal.

■

Always connect the output conductor with red pliers (+) to the positive pole of the

■

battery and the output conductor with black pliers (-) to the vehicle ground.

Never reverse the polarity; this can cause explosions, damage to the vehicle, to the

■

device and to people.

If the LED ROT / REVERSE lights up, the polarity has been reversed. Disconnect the

■

battery terminals from the vehicle and connect them properly.

Make sure the cables are out of the reach of fans, moving parts, and the fuel line.

■

Press the START / STOP button for 7 seconds, then the blue LED turns on and

■

the word „STRT" flashes on the display. From now on some protective devices are

deactivated.

Start the engine within 30 seconds.

■

The jump starter switches off automatically after 30 seconds.

■

CAUTION:

IMMEDIATELY AFTER STARTING THE ENGINE, SWITCH OFF THE STARTING

AID AND DISCONNECT THE PLIERS.

To switch off, press the START / STOP button.

■

First disconnect the output conductor from the vehicle ground with black pliers (-) and

■

immediately store it in its holder.

Then disconnect the output conductor from the positive pole (+) of the battery with red

■

pliers and also immediately store it in its holder.

If it is not possible to start the vehicle with the first few attempts, under no

■

circumstances should you continue with further attempts. Before restarting, the device

should rest for at least 3 minutes so that it is not damaged.

Charge the jump starter after each use.

■

09/2021

Page 11