a-TroniX 9887579 Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 5
Kontrolör a-TroniX 9887579 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. a-TroniX 9887579 16 sayfaları. Mppt solar charge controller
Sayfayı Yazdır
Machine Translated by Google
operation manual
MPPT solar charge controller X45/10
2. Important Safety Instructions
Be sure to follow all warnings and instructions in this manual.
Keep them safe and read the following notes carefully before installing and starting
up the device.
The operating instructions must be read and understood by all persons and
specialists who work with this device and all points must be observed.
Do not try to disassemble the device. It contains no user-serviceable parts. During
installation, operation or maintenance carried out by qualified personnel, observe
the local safety instructions and the relevant laws. Otherwise personal injury or
equipment damage may occur.
The safety instructions in this manual serve as a supplement to the local safety
instructions. Our company assumes no liability for damage caused by non-
observance of the safety instructions.
This also applies if no regular maintenance or maintenance/repairs were not carried
out by qualified specialist personnel. The device must also be set up by qualified
specialist personnel.
The solar charge controller may only be used in photovoltaic systems that comply
with these operating instructions. Likewise, only solar modules that meet the
requirements of the controller may be used. No other energy sources may be
connected to the solar charge controller.
Any further use or use that goes beyond this is considered to be improper and
can lead to personal injury, damage to property and/or damage to the device.
The batteries store a large amount of energy. Therefore, be careful not to
short-circuit the battery.
We recommend installing a fuse or circuit breaker on the positive (+)
terminal between the battery and ESC. The fuse or switch should not be
more than 15 cm from the battery post.
Batteries can produce flammable gases (oxyhydrogen). Therefore, avoid
sparks and/or flames near the battery.
Make sure the battery is in a well-ventilated place.
Avoid touching or shorting wires or terminals.
The voltage on wires or terminals can be many times higher than the
battery voltage itself.
Only use insulated tools.
Keep children away from all electrical devices/connections etc.
02/2022
page 5