Dexin KW2033 Kullanıcı Kılavuzu - Sayfa 4

Bilgisayar Aksesuarları Dexin KW2033 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dexin KW2033 8 sayfaları. Wireless radio frequency multimedia keyboard & mouse

Sayfayı Yazdır

Plug the mouse cable end into the PS/2 mouse port

PS/2 version

If you are purchasing a PS/2 version, the receiver comes with a two-headed

cable. One is keyboard cable and the other one is mouse cable. There is a small

icon on the molding head of each cable, so you can easily recognize the

keyboard cable and the mouse cable.

Keyboard cable connector

Selecting the ID Channel

The wireless keyboard & mouse have 256 different ID's to avoid interference

with other users of the same model of wireless keyboards or mice. Before using

the wireless keyboard and mouse, you must ensure that the same ID is set for the

receiver, keyboard and mouse.

Please follow the steps as below to set up:

Step 1. Installing the Batteries

This RF wireless keyboard uses a AA battery. To apply the battery, please

follow the steps below:

Turn the keyboard to the upside down.

Remove the battery cover by pressing the two tabs and pulling the cover up.

3. There are signs to indicate the placement of the batteries positive and

negative poles. Follow these signs very carefully to insert the batteries

properly. Improper insertion of the batteries may cause damage to the

keyboard.

Place the batteries cover back and make sure it is firmly closed

Step 2.

1.Turn to the bottom of the receiver and you will see a small rectangular hole

(take the cover as Fig-1) and a tact switch ID code connection.

Step 3.

Establish communication between the

receiver and the mouse (select

identification codes).

?? Press

and

release

"connect" switch on bottom of

the receiver.

?? Within about 6 seconds of the

previous step, press and release the "connect" switch on the top-

right of the keyboard.

PS/2 mouse cable connector

the

?? Now the same ID is selected on both of the receiver and the

keyboard.

Please press any key of the keyboard to check if it works. If there is problem,

please repeat the connection setting procedure once

again or check the troubleshooting guide.

Step 4. Installing the Software

PLEASE READ THIS BEFORE YOU INSTALL ANY DRIVER

Before installing the mouse driver, it is strongly recommended that you remove

all other mouse drivers and application programs

1. Insert the software CD into your CD-ROM drive.

2. The installation program should start automatically. However, if the program

does not start automatically, simply locate the 'setup.exe' file in the CD's

main directory and double-click on its icon to continue the installation

procedure.

3. Follow the on-screen instructions.

PLEASE NOTE: After software installation, your keyboard should

automatically function in any Windows environment. The wireless mouse

controller will be automatically detected by window 95,NT, 2000, ME or XP.

To Uninstall the Software

1. Keyboard Multimedia Functions- From the Windows Start Menu, locate

the Uninstall program under Programs \Media key\, and click on Uninstall

Media key to uninstall the keyboard software.

PLEASE NOTE: The Media key application should be closed first before

you uninstall the multimedia functions.

2. Mouse Scrolling Functions- From the Windows Start Menu, locate

Uninstall program under Programs \Wireless Scroll Mouse V1.20\, and double-

click on Uninstall Wireless Scroll Mouse to uninstall the mouse software

Hot-Key Functions

Note: Please make sure that both hardware and software are correctly installed

in your system before proceeding to use the Multimedia Keys.

The Multimedia Keys on the keyboard are labeled as follows:

Fig-1