Aqua Comfort Vintage Classic Series Kullanıcı El Kitabı - Sayfa 2

Yüzme Havuzu Isıtıcısı Aqua Comfort Vintage Classic Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Aqua Comfort Vintage Classic Series 14 sayfaları. Heat pump pool heaters

Sayfayı Yazdır

1. Troubleshooting Checklist

SAFETY CONSIDERATIONS

• Qualified personnel should perform installation, maintenance and service.

• Make sure all field wiring conforms to the heater specifications and all national and local

codes.

• Disconnect all power sources before performing any maintenance or service to the heater.

INSPECTION

Immediately upon receipt, inspect cartons and their contents for damage due to transit.

Damage, if found, should be noted on delivery papers and a claim filed with the carrier. Also,

check unit data plate to make sure you have the proper model, before installing.

GENERAL INFORMATION

The information in this manual was prepared to assist in the proper installation, operation,

maintenance and service of your new heat pump pool heater. Please read the entire manual

and follow all instructions. Improper installation and use can result in damage to the heater,

unsatisfactory operation, and may void the warranty. Retain this manual for quick reference.

INSTALLATION

When selecting a location consider the following:

• Heater must be located outdoors.

• Minimum of 24" of clearance on access / service side of heater.

• Minimum of 18" of clearance on all three air intake sides of heater.

• Minimum of 48" of clearance for air discharge (top of unit).

• The heater should sit on a solid level surface sufficient above grade to prevent water from

entering it, and allowing condensate to drain from base.

• The length of water piping and electric should be kept to a minimum to avoid capacity loss

and decreased efficiency.

WATER FLOW & CONNECTIONS

Water connections are made at the rear of the heater. Both water in and out are labeled at the

water connections. LEFT REAR = WATER IN and RIGHT REAR = WATER OUT.

2" unions are supplied and are made to accept 2" rigid PVC pipe. NOTE: unions can be used

for quick drainage of your heater and winterizing.

• Heater must be piped downstream from filter in the pool return line.

• Inline chlorinators must be piped downstream from heater. A check valve should be

installed between the heater and chlorinator to prevent drain back of the chlorine when

the pump is off. A chemical trap may also be piped at least six (6) inches above the

height of the chlorinator.