AvL Technologies AAQ Step Track Hold Module Kurulum ve Kullanım Kılavuzu - Sayfa 13
Kontrol Ünitesi AvL Technologies AAQ Step Track Hold Module için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. AvL Technologies AAQ Step Track Hold Module 15 sayfaları.
Sayfayı Yazdır4.2. Sensor Outputs
Path
Main Window → View→ Sensor Output
Level 0
Item
Current Signal Average
Current Signal Gradient
Current Signal Latched
Lock
Current Signal Level
Current Signal Lock
Current Signal Noise
Current Signal Source
Current Signal Type
Step Track Hold
Elevation Inc Average
Step Track Hold Pedestal
Elevation Target
Step Track Hold Target
Elevation Inclinometer
AvL Technologies
Figure 6 - Sensor Outputs
Level
0
0
0
0
The Signal to Noise ratio that is being reported by the modem in use.
This is the signal that the controller will use to peak on.
0
0
0
0
0
Based on the Configuration item, "Elevation Inclinometer Counts". This
0
After a peaking cycle is complete, the pedestal Elevation axis is latched
0
Following peaking cycle, the actual inclinometer is read here.
| Proprietary – Content is Subject to Change without Notice
Step Track Hold Tracking
Description
The average of the current signal
The rate of change of the current signal level
Reports if modem ever locked.
If the signal is above the configured threshold
The amount of noise in the current signal level.
The type of signal source being used to scan
The type of signal being picked up by scanning
is the Inclinometer averaged reading.
for current cycle. This value is read here.
12