Aqua Control AQUATIC 2HP FUSION Series Kullanıcı El Kitabı - Sayfa 11
Dış Mekan Çeşmesi Aqua Control AQUATIC 2HP FUSION Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Aqua Control AQUATIC 2HP FUSION Series 14 sayfaları.
Sayfayı Yazdır
A3
Parts Needed:
Nozzle base
x 1
Bolt
x1
1. Attatch Flare to Nozzle Base:
2. Install Flow Stoppers to the Nozzle Base:
Insert 12x Flow Stoppers into the bottom of
the Nozzle Base, secure with 12x screws
3. Attach the Nozzle Base
Stack 11 Washers in the cup
of the Outflow
Secure the Nozzle Base to the
unit using the bolt that goes
through the center hole
Fusion Series:
FLARE
.6 Nozzle Tip
Flow Stopper x12
x 1
Screw
x26
Remove the Flare(which is shipped upside down),
flip it as shown and secure with 12 x screws
Rubber
Plug x1
1x Flare Attachment
(already installed)
1.25 OD Washer
x11
Finally secure the Center
(.6)Nozzle Tip with the plug
inserted to the Nozzle base
using 2x screws
Make sure Rubber Plug is
inserted into the bottom of
the .6 Nozzle Tip