Aqua Cooler Cascade Series Kullanım ve Bakım Kılavuzu - Sayfa 7

Su Sebili Aqua Cooler Cascade Series için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Aqua Cooler Cascade Series 13 sayfaları.

Sayfayı Yazdır

indicaTor lighTS

When the indicator light is on, the unit is in the process of cooling water inside the cooler tank.

When this indicator light is on, there is no water left in the water bottle and it needs to be

replaced. Replace the water bottle, and close the door to reset the unit. The water cooler will

work again and the indicator light will turn off.

When this indicator light is on, the unit is in the process of heating water inside the heating

tank.

cleaning and mainTenance

For maximum efficiency and performance, your water dispenser requires cleaning on a regular basis (ie.

every 6 months). Regular cleaning will prevent potential growth of bacteria and will maintain a hygienic

environment.

cleaning The Waterways

IMPORTANT: Turn OFF the hot tank switch before performing this procedure.

Open the lower compartment storage door to prevent activation of the water pump. Take 8 cups (2 L)

of water from the cold faucet. Make sure the power cord is plugged into electrical outlet.

Using a clean container, mix 4 cups (1 L) of white vinegar with 4 cups (1 L) of hot water. Place the

container on the floor of the bottle storage compartment. Insert the stainless siphon tube into the

cleaning solution, keeping the container upright, and close the storage door. The water pump will

start automatically and draw the cleaning solution into the dispenser reservoirs. When all of the

cleaning solution has been drawn, the pump will continue to operate for about 20 seconds, followed

by a flashing yellow light. Open the storage door to cancel the flashing light. Allow the cleaning

solution to sit inside for 20 minutes.

Follow the reservoir draining procedure below to remove the cleaning solution.

Flush the system using 16 cups (4 L) clean water (no cleaning solution). Follow the same steps outlined

in #3. Press the hot faucet to fill up the hot tank. Once water flows from the hot faucet, allow pump

to run until it stops. Place container under drain valve and remove drain cap and drain plug, allowing

rinse water to drain. When the rinse water stops flowing, re-install the drain plug and drain cap and

tighten.

cleaning the drip Tray

Pull the drip tray forward to dislodge it from the

guides. Drain and clean the drip tray regularly to

remove spotting and mineral deposits. Use a mild

soap and water mixture or vinegar for tougher stains.

cleaning the condenser

Vacuum or sweep away the dust from the condenser

coils at the back of the dispenser to improve cooling

and efficiency.

note - Drain reservoirs before and after cleaning and

when the dispenser is not used for a long period.

draining the reservoirs

Place a container under the dispensing spigots

and press all 3 dispense buttons until water

stops flowing flowing.

Using a container, drain the remaining water

from the internal reservoirs by unscrewing the

drain cap and removing the drain plug from the

drain valve located at the back of the unit.

Once water stops flowing, replace the drain

plug and cap.