Aqua Cooler CDTT Kullanım ve Bakım Kılavuzu - Sayfa 5

Su Sebili Aqua Cooler CDTT için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Aqua Cooler CDTT 13 sayfaları.

Sayfayı Yazdır

inSTallaTion procedure

1.
Make sure the water dispenser is not plugged into an electrical
outlet.
2.
Open the door of the lower cabinet.
3.
Place full water bottle on floor. Remove the plastic cover over the
mouth of the water bottle.
4.
Place the stainless tube inside the bottle and place the water
bottle cap firmly over the mouth of the water bottle.
5.
Slide the siphon tube down until it reaches the bottom of the
bottle. See page 4, "ADJUSTING THE SIPHON TUBE".
6.
Slide the bottle inside the cabinet and close the lower cabinet
door.
7.
Read all safety precautions in this manual and then plug the water
cooler into a grounded power outlet, and turn on the green power
switch located on the back (near the top).
8.
The unit will start to operate, but wait at least an hour to use it, allowing the water to reach the proper
temperature.
9.
This unit is equipped with a switch that turns the hot tank ON and OFF. Make sure water can be
dispensed from the hot faucet before switching the hot tank switch to ON. If you are not going to use
hot water, turn the hot tank switch to OFF to conserve energy.
imporTanT noTeS
1.
If there is not a secure connection between the hose cap and the connector on the water
cooler, the water pump will operate but the water cooler will not dispense water. Make sure
the hose is connected to the stainless tube correctly.
2.
Please wait until the water pump stops running before using the unit. If the water tank is not
full, no water will dispense from the cold water or hot water faucet.
3.
Your new water cooler features an adjustable quick connect system. For proper operation,
make sure the connector is sealed tight.
4.
The connector can be removed easily for cleaning with warm soapy water.
5.
The hose cap can be adjusted up and down to accomodate both 12 L and 19 L water bottles.
5