Dexter Laundry STACK DRYER Manuel - Sayfa 6

Kurutucu Dexter Laundry STACK DRYER için çevrimiçi göz atın veya pdf Manuel indirin. Dexter Laundry STACK DRYER 6 sayfaları. Programming procedures and features

Sayfayı Yazdır

CHANGING PROGRAMMED DATA : ENTERING PROGRAM MODE

The controller is put into the programming mode by opening both dryer doors and pushing the

program switch (shown in a previous pictures) on the back of the controller circuit board. The

switch is accessed by unlocking the controller and sliding it out just enough to reach the switch.

PROGRAMMING

The upper display shows the setting for each step of the program as you go through the list.

The lower display gives the number of the program step as given on the previous program

step chart (00-16).

The lower "Hot switch" will advance the controller through the seventeen steps which can be

observed or altered. Each step can be identified by the step number in the lower display.

The upper and lower "Start switches" increase and decrease the values in the upper display

by the increments given in the program step chart.

The lower "Perm press" switch will return the value for the step being displayed to the original

value given on the program step chart. Note: For the hour meter and the money audit steps this

value is zero.

EXITING PROGRAM MODE

The controller remains in the programming mode until one of the following happens:

1. The mode switch is pushed again.

2. The sixteenth and last step of the programming sequence is completed

(first step is 00, last step is 16) and the step switch is pushed following this step.

3. Programming is stopped for approximately one minute.

4. The dryer doors are closed.

PROGRAMMING EXAMPLE :

For an example we will change the vend price from $.25 to $.50.

STEP

1. Open upper and lower loading doors.

2. Unlock the control tray and carefully slide it about 3 inches out of the machine.

Press the program switch behind the vertical portion of the circuit board. Replace and

relock the control tray in its original position.

3. Consult program chart to find vend price as step 09. Push lower "Hot" button to

advance through steps until 09 is displayed in lower display. Current vend price

(25 in this case) will be displayed in upper window.

4. Push upper start button to increase price by increments of 5 until 50 is reached and

shows in the upper display.

NOTE: To make any change it is necessary after changing the value to

press the lower "Hot" and advance one more step in order for the new

value to be entered into the computer memory.

5. Exit the program mode by any of the methods previously mentioned.

6. The displays should now show "50" as the price to start the machine.