Avlite AV-HLI2 Kurulum ve Servis Kılavuzu - Sayfa 13
Aydınlatma Ekipmanları Avlite AV-HLI2 için çevrimiçi göz atın veya pdf Kurulum ve Servis Kılavuzu indirin. Avlite AV-HLI2 16 sayfaları. Inset heliport light
Ayrıca Avlite AV-HLI2 için: Kurulum ve Servis Kılavuzu (12 sayfalar)
Sayfayı Yazdır
Direct Mounting:
The procedure for installing an inset light fixture to a pre-prepared mounting surface is as
follows:
•
Ensure the M5 screw holes and flange area are clean
•
Lower the light fixture onto the mounting surface, ensuring all electrical connections
are properly terminated and fly lead is free and clear of the mounting surface
•
Align the screw holes of the inset light fixture with those of the mounting surface and
fasten using silicone greased M10x15 counter sunk screws
•
Tighten screws to 3.5 Nm
Note: Continuous Immersion of the light (body) into water/fluids:
It is required to install the light in such way that no frequent or continuous immersion of
the light or parts in water or other fluids take place. Therefore it is recommended to use
the shallow base, either connected to a drained duct system or by inserting the cables
(sheated cable OD 7-13mm) through the cable glands and tightening them with 12 Nm
torque. When inserting the lights in the shallow base, ensure the provided sealing "O-ring"
is in the correct position below the flange of the light and in the chamfer of the shallow
base. Apply anti-seizing to the 4 screws and tighten the screws with 4.9 Nm crosswise.
Note: Intrusion of water through the supply cable:
The open ends of the power supply cables of the light and on the construction side shall
not be immersed into water at any time of the installation. If this accidentally happens, the
lines need to be dried by unstripping the cable ends and storing them in a drying agent (eg.
a bag with silica gel and tyrap) for a minimum of 5 days. For connection, we recommend
the usage of gel filled joints suiting 0.75mm² up to 4mm² wiring. If an intrusion of water
in the bases or pits cannot be avoided, the joints should be placed in such way that no
immersion in water or other fluids can take place.
Latest products and information available at www.avlite.com
AV-HLI2 - Inset Heliport Light
Installation & Service Manual
13