Dexter Laundry T750 EXPRESS Kurulum ve Çalıştırma Talimatları - Sayfa 8

Yıkayıcı Dexter Laundry T750 EXPRESS için çevrimiçi göz atın veya pdf Kurulum ve Çalıştırma Talimatları indirin. Dexter Laundry T750 EXPRESS 17 sayfaları. 50lb capacity computer control coin washer

Sayfayı Yazdır

PROGRAMMING INSTRUCTIONS:

Programming can be accomplished manually using the machine controls or by connecting to the

machine control using a PDA (personal digital assistant). For instructions on using a PDA with

this washer control, please contact your local Dexter distributor. Please read below for manual

programming instructions.

The washer has two levels of programming. The Coin/Price Programming allows the owner to

set the price for the washer features and the values of the coins. The Washer Cycle Programming

allows the owner complete access to the wash cycle parameters – add/remove a bath, bath times,

spin times, water temperatures, etc. To enter the programming modes, the top of the washer must

be unlocked and slid toward the back of the washer a few inches.

COIN PRICE PROGRAMMING

While the washer is in the Idle mode, push the Programming pushbutton on the controller. The

Idle mode is when the washer is not running a cycle and the price of the bath is displayed. The

Programming pushbutton is a very small button located on the upper center of the controller

directly behind the display. There are seven stages in the Coin/Price Programming mode.

To step through to the desired stage, repeatedly push the START button until the desired

stage is blinking on the display. To exit the Coin/Price programming mode, push and hold

the Cold temperature button for 5 seconds.

Stage 1: Right Coin – The display will blink first a "r" indicating right coin and then a coin value

($1.00 – default). The display will blink back and forth between the "r" and the value. To

change the value, use the Hot temperature button to decrease and the Warm temperature button

to increase. The value will change in 1¢ steps. The range of values is from $00.00 to $99.99.

When the desired right coin value is displayed, push the Start button once to store the new value

and a second time to move to the next Coin/Price programming step. To exit the Coin/Price

programming mode, push the Cold temperature button for 5 seconds.

Stage 2: Left Coin – The display will blink first a "L" indicating left coin and then a coin value

($0.25– default). The display will blink back and forth between the "L" and the value. To

change the value, use the Hot temperature button to decrease and the Warm temperature button

to increase. The value will change in 1¢ steps. The range of values is from $00.00 to $99.99.

When the desired left coin value is displayed, push the Start temperature button once to store the

new value and a second time to move to the next Coin/Price programming step. To exit the

Coin/Price programming mode, push the Cold temperature button for 5 seconds.

Stage 3: Wash Price – The display will blink first a "P" indicating wash price and then present

wash price. The display will blink back and forth between the "P" and the price. To change the

value, use the Hot temperature button to decrease and the Warm temperature button to increase.

The value will change in 1¢ steps. The range of values is from $00.00 to $99.99. If the wash

price is set to $00.00, the display will show "FREE" after exiting the programming mode. When

the desired price is displayed, push the Start button once to store the new value and a second

time to move to the next Coin/Price programming step. To exit the Coin/Price programming

mode, push the Cold temperature button for 5 seconds.