Aqua Creek Products ACF-SCTXL Manuel - Sayfa 8

Kaldırma Sistemleri Aqua Creek Products ACF-SCTXL için çevrimiçi göz atın veya pdf Manuel indirin. Aqua Creek Products ACF-SCTXL 15 sayfaları. Pool lift

Sayfayı Yazdır

TOOLS REQUIRED:

1/2" WRENCH

9/16" WRENCH

3/4" WRENCH

Lift the Scout Excel MAIN ASSEMBLY from the shipping container. Insert the 1.9" [48mm] post

of the MAIN ASSEMBLY into the deck anchor (FIGURE A, PAGE 6). Ease the MAIN ASSEMBLY down

until it rests on the deck surface. Rotate the base until the fi xing anchor hole lines up with the

fi xing anchor. Install the 1/2" x 1 1/2" hex bolt and washer to hold down the lift. Tighten the bolt.

Remove the shipping strap and all packing from the ACTUATOR. Connect the LIFTING ARM

between the mast and the ACTUATOR (FIGURE D). Tighten nylock nuts (PHOTO 1 & PHOTO 2).

PHOTO 1

PHOTO 3

NOTE: Be careful not to over-tighten bolts.

Over-tightening can cause damage and

compromise the safety of your lift.

Scout Excel Assembly Instructions

3/16" ALLEN WRENCH

1/4" ALLEN WRENCH

PHOTO 2

WARNING:

NEVER LIFT THE MAIN ASSEMBLY

USING THE LINEAR ACTUATOR AS A HANDLE! USE

AT LEAST TWO PEOPLE TO LIFT. USE A TRANSPORT

CART IF AVAILABLE.

3/8"-16 NYLOCK NUT

3/8" FLAT WASHER

SHOULDER BOLT

LINEAR

ACTUATOR

NOTE: The LIFTING ARM is easily fl ipped

around the wrong way. Make sure the end

marked "B" is towards the mast, as shown.

1/2" X 2 3/4"

('B' END: SEE NOTE)

5/16"-18 NYLOCK NUT

5/16" FLAT WASHER

3/8" X 2"

SHOULDER BOLT

SCOUT LIFTING ARM

(LONG END: SEE NOTE)

FIGURE D

Revised 4/20/20