Aqua Creek Products EZ Series Manuel - Sayfa 6

Kaldırma Sistemleri Aqua Creek Products EZ Series için çevrimiçi göz atın veya pdf Manuel indirin. Aqua Creek Products EZ Series 11 sayfaları. Pool lift and hard seat option
Ayrıca Aqua Creek Products EZ Series için: Hızlı Başlangıç Kılavuzu (2 sayfalar)

Sayfayı Yazdır

TOOLS REQUIRED:

9/16" WRENCH

The EZ Pool Lift arrives with the boom arm attached to the mast. To

complete the assembly, layout all parts on a large, clean area.

1. Locate the hydraulic ram and attach the upper end of the hydraulic

ram to the boom with one (1) 3/8" x 1-3/4" hex head bolt, two (2) 3/8"

fl at washers and one (1) 3/8" nylock nut. See Step 1.

2. Connect the lower end of the hydraulic ram to the mast with one

(1) 3/8" x 1-3/4" hex head bolt, two (2) 3/8" fl at washers and one (1)

3/8" nylock nut. See Step 2.

WARNING!! MAKE SURE THAT THE 3/8" ROD END IS ALWAYS FULLY

SEATED WITH THE MAXIMUM ALLOWABLE THREAD BEING USED.

3. Install lift into previously installed anchor socket in the pool deck.

Make sure that the mast is seated at the bottom of the anchor. Check

to ensure easy rotation of the lift in nylon lined anchor sleeve.

4. Locate the chain assembly and insert the quick links

into the holes in the sling support bars (A).

Attach the hanger to the boom eye on the lift (B).

Adjust the chain links so that the sling is at the appropriate height to

allow the user easy access (C). This may require several adjustments.

Also, be mindful of any obstacles such as coping or a gutter that will

need to be cleared. See Step 4.

Assembly is complete. Prior to lifting any persons, it is recommended

that the lift be operated 3-5 times without a load for the lifts "break

in" period as well as to check for proper functioning (and that the

instructions for operating the lift be read and incorporated into a

training program for the persons who will be operating the lift).

For any person operating the lift, please continue to operating

instructions. Read carefully for comprehension.

Assembly Instructions

3/4" WRENCH

3/8" NYLOCK NUT

STEP 1

BOOM ARM

3/8" FLAT

WASHER (2)

3/8" X 1 3/4"

HEX BOLT

MAST

STEP 2

MAST

3/8" NYLOCK

NUT

3/8" FLAT

WASHER (2)

3/8" X 1 3/4"

HEX BOLT

STEP 4

Revised 11/1/19

ACTUATOR