Aqua Creek Products F-004XRDD-NA Manuel - Sayfa 11

Kaldırma Sistemleri Aqua Creek Products F-004XRDD-NA için çevrimiçi göz atın veya pdf Manuel indirin. Aqua Creek Products F-004XRDD-NA 18 sayfaları. Pool lift without anchor

Sayfayı Yazdır

PROCEDURE

Wash down lift with fresh water and dry with clean, soft,

non-abrasive cloth

Recharge battery

Run the lift through a complete test cycle to verify it is

functioning properly

Visually inspect lift for damage, corrosion, and loose or

missing hardware

Check all contact points for damage and/or corrosion

Repair, clean, and apply dielectric grease to all contact

points

Thoroughly clean lift frame and apply a liberal coat of car

wax to maintain the lift's finish

Check all Warning and Cautionary labels to make sure they

are not faded or worn. Replace as needed.

PROPER CARE NOTES

• Use only fresh water to wash your lift. Do not wash with pool water

• Use only clean, soft, non-abrasive cloths to wipe down your lift

• Do not store lift in pump room or near chemicals

• Do not allow children to play on or around this lift

• When cleaning the lift do not spray water directly on control box or battery

• The lift may need to be bonded according to local code requirements

STAIN REMOVAL TIPS:

To remove stains wash affected area with mild dish soap. For stubborn spots and stains

try using soft scrub with some brisk rubbing. Use white epoxy paint to touch up. Apply

wax to finish.

For service and/or replacement parts contact Aqua Creek Direct at

Proper Care of Pool & Spa Lifts

Toll free: (888) 687-3552

DAILY

WEEKLY



Revised 12/3/15

MONTHLY

