Aqua Creek Products F-12PPL-HD-AT2-05 Manuel - Sayfa 6

Kaldırma Sistemleri Aqua Creek Products F-12PPL-HD-AT2-05 için çevrimiçi göz atın veya pdf Manuel indirin. Aqua Creek Products F-12PPL-HD-AT2-05 14 sayfaları. Portable lift

Sayfayı Yazdır

Patriot-AT2 Fixing Kit Installation Instructions

• Core-drilling rig

• 1-1/4" diameter core-drill

• 3/4" wrench or socket

NOTE: Fixing Kit installation is only required for ADA applications.

FIXING BOLT

(

1/2-13 X 4-1/2")

1/2" FLAT WASHER

BRAKE FOOT

PVC ANCHOR INSERT

clean off any excess. Allow 24 hours for the epoxy to cure.

Roll the portable cart over the installed anchor. Align the anchor with the fixing bar.

Drop the fixing bolt into the fixing bar and, by hand, start to thread into the anchor

insert. If needed, adjust the alignment of the lift.

When properly aligned, complete threading with a 3/4 inch wrench or socket.

Tighten until the bolt just touches the flat washer. DO NOT OVERTIGHTEN.

TOOLS REQUIRED:

• 2-part construction epoxy or equivelent

• Tape measure

• Marking pen

Determine the location of the

anchor insert, allowing for the ADA

compliant clear deck space. (see

FIGURE 1, page 3)

Mark the location for the 1-1/4

inch x 4 inch deep anchor hole.

Using a core-drill, drill a 1-1/4 inch

diameter, 4 inch deep hole at the

marked location.

Dry-fit the anchor insert to make

sure it fits flush with the deck

surface.

Fill the hole 1/2 full with epoxy (or

equivalent). Install the anchor insert

flush with the deck surface and

Revised 6/18/19