ab Aqua Medic mV-Computer Kullanım Kılavuzu - Sayfa 4

Tıbbi Ekipman ab Aqua Medic mV-Computer için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ab Aqua Medic mV-Computer 6 sayfaları.

5. Adjustment of the control direction

The status of the control direction is show ant the LEDs at the side(3):

Low – an adjusted minimum set point is controlled by the addition of an oxidising agent ( e.g.

ozone). The direction of control is upwards. This is the standard mode for control of the ORP with

Ozone in marine aquariums or for the control of a Nitratereductor with air or a dosing pump.

High – an adjusted maximum set point is controlled by the addition of an reducing agent. The

direction of control is downwards. To change the control mode between High and Low, press the

Prog/Enter and the High/Low button simultaneously. The actual mode is shown by the LEDs (3).

6. Adjusting the set point

To adjust the set point, press the Prog/Enter and the SET buttons simultaneously. The adjusted set

point is now shown on the display – flashing. It can be changed with the + and – buttons. By

pressing the Prog/Enter button again, the set-point is saved. and the display switches back to the

actual value.

The hysteresis should be between 5-10 mV. If it is too low, the computer will switch on and off in a

very short time. If it is too high, the accuracy will be bad.

7. Sensor calibration

The measurement of the redox-potential is an absolute measurement of voltage. The mV-

Computer does not need to be calibrated. Differences may be caused by the electrode. They can be

checked with the included standard solution. If the differences are small ( 10 – 15 MV) the probe

can be still used. If the differences are higher, the probe must be cleaned, refilled or replaced.

For continuous measurement of the redox-potential, the probe must be securely placed 5 cm below

the surface of the water and the shaft has to be kept dry (we recommend the AB Aqua Mdeic

electrode holder).

The unit is now ready for use. As soon as the redox-potential value falls below or above the desired

adjusted value, the unit activates the power plug. This is indicated by the LED out (5)

8. Probe

The AB Aqua Medic probe is specifically designed to determine the redox-potential in fluid based

solubles. It can be used in the chemical industry, medical areas and in research labaratories.

8.1 Technical Data

Measurement range:

Sample temperature:

Connection:

Material:

8.2 Measurement/Maintenance

During the measurement the platinum tip must be continuously submerged in the solution.

A new probe or one which has been dry for a longer period must lay in water for at least 24 hours.

1,000 - +1,000 mV

5-60° C, short-term

BNC-plug

Plastic shaft, Polysulfon, platinum tip