Aqua Creek Products REVOLUTION LIFT SD SLING F-706RLSS Manuel - Sayfa 16

Kaldırma Sistemleri Aqua Creek Products REVOLUTION LIFT SD SLING F-706RLSS için çevrimiçi göz atın veya pdf Manuel indirin. Aqua Creek Products REVOLUTION LIFT SD SLING F-706RLSS 20 sayfaları.

Sayfayı Yazdır
CARE OF YOUR LIFT
Routine cleaning is an absolute necessity to ensure the integrity of the lift. Note that the Aqua Creek Pool
Lift should not be stored in a pump room or in a storage room where pool chemicals are kept. Storing the
lift near pool chemicals may cause rusting and other damage to occur. Your Aqua Creek stainless steel lift
is powder coated to protect the stainless steel from rusting. Most rusting will occur at weld points,
crevices, under gaskets, rivets or bolt heads.
The choice of a proper cleaning product is up to the consumer and there are many to choose from.
Depending on the type of cleaning and the degree of contamination (rusting), some products are better than
others. For routine cleaning the products most recommended are gentle soaps or detergents or dilute
mixtures of ammonia. For stubborn spots and stains try using soft scrub with some brisk rubbing.
DO NOT USE POOL WATER TO CLEAN USE ONLY FRESH
WATER
If the lift is used DAILY make sure to wash the lift at the end of the day. Wash the lift off using a mild
soap and a soft cloth. Make sure to pay special attention to weld points and crevices. Do not use a bristled
brush or steel wool to clean the lift. Check that the lift is working properly and then place the battery on
the charger. It is recommended that the battery be charged after every day of use.
If the lift is used WEEKLY follow the same steps as above. Also be sure to check all of the contact points
(terminals) for damage or corrosion. If you notice corrosion gently clean the terminals. To clean corrosion
from the terminals use a q-tip and some rubbing alcohol. If the corrosion is particularly stubborn try using a
3M scotch brite pad, but be careful not to damage the terminals. Apply dielectric grease to the terminals
after cleaning them. This will help to prevent further corrosion. Do not leave the battery on the lift. Always
store the battery on the charger whenever the lift is not being used.
If the lift is used MONTHLY follow the same steps as above. Also check the nuts and bolts to make sure
they are securely fastened (this is always a good idea, no matter how often or infrequently the lift is used).
Also make sure to store the battery on the charger and not on the lift. Leaving the battery on the lift for
e x t e n d e d p e r i o d s w i l l s i g n i f i c a n t l y s h o r t e n t h e b a t t e r y ' s l i f e s p a n .
If the lift is being STORED for an extended period of time follow all of the steps above. Check for rusting
at all crevice and weld points. If you notice rusting spray some WD-40 on the affected area and take a 3M
scotch brite pad and rub briskly. Afterwards be sure to wash and rinse the lift again with soap and water.
When storing the lift make sure it is in a dry area and covered. DO NOT STORE in or around pool
chemicals.
16