Aqua Creek Products F-MTY400 Manuel - Sayfa 13

Aydınlatma Ekipmanları Aqua Creek Products F-MTY400 için çevrimiçi göz atın veya pdf Manuel indirin. Aqua Creek Products F-MTY400 13 sayfaları.

PROCEDURE

Check battery level indicator on control box.

Run the lift through a complete test cycle (fully

extend actuator) to verify it is functioning

properly.

Wash lift with fresh water and dry with clean,

solft, non-abrasive cloth.

Recharge battery.

Visually inspect lift for damage, corrosion, and

loose or missing hardware.

Check all contact points for damage and/or

corrosion.

Repair, clean and apply dielectric grease to all

contact points.

Thoroughly clean lift frame and apply a liberal

coat of car wax to maintain the lift's finish.

Check all Warning and Cautionary labels to

make sure they are not faded or worn. Replace

as needed.

PROPER CARE NOTES:

• Use only fresh water to wash your lift. Do not wash with pool water.

• Use only clean, soft, non-abrasive cloths on your lift.

• Do not store lift in pump room or near chemicals.

• Do not allow children to play on or around this lift.

• When cleaning the lift, do not spray water directly on control box or battery.

• The lift may need to be bonded according to local code requirements.

• If the lift is not used for extended periods, remove the battery from the lift and

store it on the wall charger to maintain the battery's charge. The charger should be

plugged in and in a climate controlled area.

STAIN REMOVAL NOTES:

To remove stubborn stains from finish, spray affected area with mild dish

soap, rub briskly with a 3M Scotch Brite™ pad. Use white epoxy paint to

touch up the finish. Apply wax to protect when dry.

PROPER CARE OF LIFTS

For service and/or replacement parts, contact

DAILY

BEFORE

EACH USE

Aqua Creek Products

Toll free: (888) 687-3552

WEEKLY

MONTHLY

9/28/2022 1:39:29 PM PAGE - 13