AVM evolution m3ng Kullanım Talimatları Kılavuzu - Sayfa 7

Amplifikatör AVM evolution m3ng için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. AVM evolution m3ng 10 sayfaları.

2.2 Placement of the unit / cooling

The M3NG can warm up considerably - depending on the required output power. It is therefore very

important that air circulation is possible to both the sides and underside of the unit and that heated air can

vent upwards. This will allow good heat dispersion. Locate the M3NG in such a way, that a minimum of 10

cm free space is maintained around the unit to any other equipment or walls. If the unit is placed on a carpet

you should ensure that the feet do not sink into the pile (if necessary place blocks underneath) and that air

vents are not sealed by the pile of the carpet. Please also ensure the unit is protected from direct sunlight.

A TIP

It should also be remembered that heat sensitive objects such as candles, plastics, records or CD's may be

damaged by the generated heat. The installed transformers emit magnetic stray fields. To prevent

interference you should under no circumstances place the M3NG either directly on or near the pre amplifier

or record player.

NOTE

Great care should be taken to ensure that small children do not burn themselves by accidentally

touching the Mono amp. The casing does not feel extremely hot to adults but small children

generally react more sensitively.

Do not connect your loudspeakers when taking the unit into use for the first time. Set the mains switch (9) to

"0", set the mode selector switch (7) to "auto", and leave the inputs open. Connect the power supply socket

(10) with a cable to the mains and set the mains switch to "I". The control LED (1) glows. The unit is now in

"stand-by" mode. Operating voltage is only being supplied to the automatic start up circuitry. The remaining

amplifier circuitry is without power.

Set the mode selector (7) to "permanent". Now the LED (1) lights up. At this moment you will hear clicks in

short succession from the switching relays of the supply unit and speaker output. The amp is activated.

When this initial check is passed, switch the amp off.

The incorporated automatic start circuitry relieves you of switching the Mono amp on and off when the mode

selector (7) is set to "auto". For this the main supply switch (9) must always be set to "I". Your M3NG then

switches on automatically as soon as the pre amplifier delivers musical signals and off when the pre amplifier

has not delivered a signal for more than 5 to 10 minutes.

If you wish to switch the M3NG personally on or switchable mains sockets are used you can set the mode

selector (7) to "perm" and activate the unit with the main supply switch.

If your preamplifier is equipped with a trigger output (such as for example the AVM V3NG) you can connect

this output to the M3NG's trigger input (8) (see also 2.1.4 connection trigger input) and set the M3NG's mode

selector (7) to "trigger". Then the M3NG will switch on and off simultaneously with your preamp.

NOTE

If the M3NG is in stand-by mode and the automatic start circuitry is activated, the device is not

completely separated from the mains supply. To protect your unit from damage during a

thunderstorm or prolonged absence, it is recommended that you disconnect the mains plug (10).