AVM PA 30.3 Kullanım Talimatları Kılavuzu - Sayfa 15

Amplifikatör AVM PA 30.3 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. AVM PA 30.3 20 sayfaları.

2.8 Sound settings (Bass/Treble)

By pressing and holding the balance button BAL (8) the right-left balance of the output signal

can be adjusted globally for all input channels by means of the volume control (9). The current

setting is shown in the display (6) on the right side while the BAL button is pressed. As soon

as you release the button, the set value is stored and the unit returns to its normal operating

state.

The integrated tone control electronics for adjusting the bass or treble components of the PA

30.3 is activated as soon as you make a setting under BASS or TREBLE. If a neutral setting

(BASS = 0, TREBLE = 0) is selected, the tone control electronics will remain deactivated until

one of these parameters is changed. The display will show TONE ON when the tone control is

activated and LINEAR when it is deactivated.

The RESET option offers you the possibility to reset the device to the original delivery state

and thus to all factory settings. The following settings are reset in the course of a RESET:

ü Individual input sensitivities (level settings). For details see section 2.6.

ü Cross-channel adjustments of the right-left balance (see section 2.7) and the bass/treble

sound settings (see section 2.8)

ü AV Pass Through function for high level inputs (17,19) (see section 1.11)

ü AV Pass Through Funktion für Hochpegel-Eingänge (17,19) (siehe Abschnitt 1.11)

To perform a RESET, switch off the device with the mains switch (26) on the back. Then press

and hold the TREBLE button (3) and the LEVEL button at the same time and switch the unit

on again with the power switch (26) on the back. Now press the BAL button (8) to perform the

RESET or BASS (4) to cancel the process. Wait until the unit changes to standby mode. Your

PA 30.3 integrated amplifier is now reset to its factory settings.

The PA 30.3 integrated amplifier is equipped with an energy-saving automatic power-off. If no

music is played for a period of 20 minutes or no function is activated on the unit, the PA 30.3

automatically switches to standby mode. By pressing the on/off button (2) the unit can of

course be switched on again at any time.

The automatic switch-off can be deactivated or reactivated as follows: Switch off the unit with

the rear power switch (26). Keep both keys BASS (4) and TREBLE (5) pressed and switch on

the unit with the rear power switch (26). Depending on the selected setting, the display appears:

AUTO OFF ACTIVE or AUTO OFF NOT ACTIVE. You can change the setting by repeatedly

pressing the LEVEL button (7) and then permanently store it by pressing the POWER button

(2).