AVM EVOLUTION CD2 Kullanım Talimatları Kılavuzu - Sayfa 4

CD Çalar AVM EVOLUTION CD2 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. AVM EVOLUTION CD2 19 sayfaları. Cd-player evolution

Sayfayı Yazdır

relativity of the needed frequencies always remains exactly equal and therefore all assemblies are optimally

synchronized.

By the use of upsampling the stream of information is independent of the 44.1 kHz clock pulse. Intermediate

storage in a buffer followed by its chronologically correct output ensures that the converter is not affected

by drive induced jitter.

The front of the C02 is clearly defined and contains all of the operating elements necessary for the basic

functions. This permits clarity and simplicity of operation. Of course the C02 can do much more: Title pro-

gramming and special functions, such as the ability

switch the digital filter, are available through the remo-

te control.

MECHANICAL CONSTRUCTION

The modules, power supply, drive controller, output stages are situated on separate IC boards. This reduces

mutual influence to a minimum. The casing of the C02 is manufactured from magnetically protecting steel

plate. The built-in power transformers are of the low-scatter toroidal type.

The output sockets of the C02 have surface treated contact areas to promote good contact and durability.

Epoxy resin circuit boards and the use of selected brand named, high quality components ensure that you

will have a lot of enjoyment from your AVM C02.

THE POWER SUPPLY

In the same way that we believe that separation of the drive and the O/A converter provides an optimal

tonal solution due to the absolute freedom from reaction it is also our opinion that the individual modules

of a CO player should not mutually influence each other. For the reason the C02 has two power supplies

that are fed from low impedance toroidal transformers. One is mainly for the supply of the servo electro-

nics or alternatively the audio digital section whereas the other delivers current to the O/A converter and

output stages

THE DIGITAl SECTION

The output signals of the drive are received by the sampling rate converter CS 8420.This increases the pulse

rate of the data bits from 16 Bit/44.1 kHz to 24 Bit/96 kHz or alternatively 24 Bit/88.2 kHz. This integrated

circuit removes any existing jitter completely from the signal (up to the physically unavoidable minimum)

before it passes it to the digital filter.

The digital filter situated behind the sampling rate converter ensures that unwanted frequency components

(aliasing) are removed from the signal flow. For this purpose two filter variations are available. In the selec-

tion "sharp" the signal amplitude falls steeply at the end of the transmission range whereas the selection

"slow" causes a flatter fall off of the amplitude towards the cut-off region. With both variants the complete

audio bandwidth is retained so that you can adjust the tonal qualities of the C02 to your listening prefe-

rences.