AVM OVATION CD 6.3 Kullanım Talimatları Kılavuzu - Sayfa 10

CD Çalar AVM OVATION CD 6.3 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. AVM OVATION CD 6.3 19 sayfaları.

Tube warmup (CD 8.3)

Due to the warm-up phase of the integrated tube line stage, the power-on time of the CD 8.3

is extended by approx. 30 seconds.

CAUTION: When switched to stand by the unit is still connected to the mains. In case of a

thunderstorm or if you leave the house for a longer time, we recommend you switch the

amplifier off by using the mains switch (29) or pull the mains plug (28).

2.3 Display

When the unit is on, the display (9) shows information about the current settings and state of

your CD Player. Apart from informations about the operating status (CD Player, Digital Input

etc.) the lower line shows you currently active settings of the D/A converter: On the left-hand

side the sample rate (e.g. "192") and bit depth is displayed. On the right-hand side, you will

find the current filter setting (SMOOTH or STEEP).

2.3.1 Display in CD player mode

TRACK

On the left-hand side both the current title is displayed (big figures) and the total number of

available tracks of the inserted CD (small figures).

TIME

At the centre of the display the total duration of an inserted CD is displayed, while stopped

(STOP). As soon as the CD is played (PLAY) or paused (PAUSE), the time already elapsed of

the current track is displayed.

STATUS

On the right-hand side the current operating status is displayed (STOP, PLAY, PAUSE).

PROG

In case of a currently active track programming both the currently playing track and the total

number of programmed tracks is displayed on the left-hand side (for example "PROG 2/17").

RND

In case the random play mode is activated, the currently playing track and the total number of

programmed tracks are displayed on the left-hand side (for example "RND 5/12").

2.3.2

Display in D/A converter mode

On the left-hand side the name of the currently selected input is displayed. If there is no

incoming signal available at the currently selected input, NO DIG SIGNAL or NO USB

PLUGGED is shown right next to the input name.