AVM EVOLUTION C 5.2 Kullanım Talimatları Kılavuzu - Sayfa 12

Araç Alıcısı AVM EVOLUTION C 5.2 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. AVM EVOLUTION C 5.2 15 sayfaları.

3.3 Personal setup

The personal setup offers you a range of settings to individualize the device according to your personal

needs. To enter the personal setup menu, please switch off your device on the rear of the unit at the

mains switch (29). Keep the most right key under the display pressed (9) while you switch on the unit

again (29). As soon as the display shows the personal setup menu you can release the multifunctional

button (9).

When the personal setup is active you can select the desired function using the buttons < ITEM >. The

button SELECT activates the function. The setting is done using the buttons < VALUE4 >. BACK leads

you back to other settings. EXIT exits the personal setup and stores the settings.

Sets display brightness 25% to 100%.

NOTE: The setting 100% can lead to "burn in" effects on the display if the unit is operated in this

setting for a very long time. So please switch the unit to stand by, if not in use.

3.3.2 Bass & treble control

Choose if you want to change bass and treble settings simultaneously for all inputs ("global") or

especially for the actual input ("individual").

Deactivate unused inputs ("SKIP"). The unit will then skip these inputs when the source selector (2) is

pressed or if you select the inputs via the RC 3 remote control.

You can individually set the names (max. 8 characters) of the different sources shown in the display

(10). Proceed as follows:

Press SELECT. The display shows now on the left side the old name, on the right side the new name.

The character to change is marked by an underscore. The keys < ITEM > (5, 6) select the input, the

keys < POS > (8, 9) select the position of the character to change. The marked character can be set

using the volume knob (11). When you are ready, simply press BACK (7). and the new names will be

stored.

In a surround system the channel balance, tone setting and bass management are done by the

decoder. This setting must not be altered by another component because the channel balance the

would be incorrect. For this application the C 5.2 offers the fixed gain function (only for inputs 1-3).

Set the input where the main channels of the surround system are connected to fixed gain. When this

input is selected, tone controls are bypassed, balance is set to neutral position and the gain is on a

fixed level independently of the volume setting on the other inputs.