Femooi FH1.0 Kullanım Kılavuzu - Sayfa 14

Cosnetic Ekipman Femooi FH1.0 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Femooi FH1.0 16 sayfaları.

Maintenance

Please maintain HiMESO™ properly and keep it in the best working condition

· After each use, please clean the cover and the slots inside of the device thoroughly with

a clean cloth or towel, and wipe them dry.

· Please wipe the charging base with a soft cloth or towel.

· After ﬁnishing the Nano Meso Mode and Phototherapy Mode, please remove the cartridge

with serum and clean the Cartridge with serum installation slot.

· Please do not use cleaning products containing alcohol, gasoline, or acetone to clean the

device. These substances may irritate the skin.

· Please do not place HiMESO™ in an acidic or alkaline liquid.

· Please do not put HiMESO™ in a dishwasher, microwave oven or high-pressure container,

otherwise it may cause an accident or cause injury.

· Please do not wash the HiMESO™ device with water.

· The device must not be immersed in water.

· Please avoid exposure to high temperatures, moisture, heavy pressure and impact.

· Please keep the product out of reach of children to prevent accidents.

· Please do not use it near electrical appliances such as TVs and radios.

· Please do not use while the product is charging.

· Please charge HiMESO™ when it is in a low battery state to extend the battery life.

· Please use the original charging dock and charging cable of HiMESO™.

· Please do not disassemble, modify or repair the device by yourself.

· Please use the product only for the speciﬁc purposes described in this manual.

The most frequently asked questions about HiMESO™ are listed below.If you cannot ﬁnd

proper answers, please call the customer service hotline for more information.

The indicator light of HiMESO™ does pulse in the breathing rhythm after the charger is

connected

The battery is completely depleted and it can take a few minutes to recognize the charger.

The HiMESO™ device is not properly placed in the charging base.

The HiMESO™ charging cable connector or power charger are not connected properly.

HiMESO™ does not respond after pressing the function mode button

The device is turned oﬀ.Please press and hold the power button for 1.5 seconds to turn on

the device.

The battery is depleted.Please charge the device.

The microprocessor has a temporary malfunction.Please connect the charging cable to

restore its function.

Cannot switch to other modes

Please ensure that the buttons and ﬁngers are clean and try again.

If the device cannot switch during use, there may be residual essence in the device. Please

put it in a ventilated place to dry for one to two days before trying again.