AVMATRIX TS3019 Kullanıcı Kılavuzu - Sayfa 12

Endüstriyel Ekipmanlar AVMATRIX TS3019 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AVMATRIX TS3019 14 sayfaları. Wireless tally system

Sayfayı Yazdır

Vmix Connect TS3019：

Step 1: Configure Tally box and Tally lamp

Set the input of Tally box to USB-C (SW1:1, SW2:0). Set the Tally lamp to 1, 2, 3, 4 respectively.

Step 2: Use a USB A to C cable to connect the USB Type C port of the Tally box and the USB-A port of

the PC. Look at the Device Manager on the PC to check the status of the COM port connected to the Tally

box. The figure below shows COM3.

Step 3: Set up Vmix software

Open the Vmix setup, click Tally Lights and reset to default mode as shown below.

Users can increase PIN according to the actual number of Tally lamp. (For example, if you want to

connect 6 Tally lamps, you need to fill in PreviewPIN and ActivePIN in order from 2.3 of the lamp 1 to the

lamp 6 according to the rules, and then click to confirm), as shown in the following figure.