aqua greek products Pull-Out Legrest Talimatlar - Sayfa 3

Kaldırma Sistemleri aqua greek products Pull-Out Legrest için çevrimiçi göz atın veya pdf Talimatlar indirin. aqua greek products Pull-Out Legrest 3 sayfaları.

Sayfayı Yazdır
3. Orient the pull out legrest as shown below and slide the plastic guide/spacer into the chair support
tube. Tap the palstic guide/spacer with a hammer or mallet until ush with the end of the support
tube. The threaded hole in the bottom of the plastic guide/spacer should line up with the hole
drilled in the support tube. Install the washers and 1/4"-20 x 1/2" cap screw from underneath and
drilled in the support tube. Install the washers and 1/4"-20 x 1/2" cap screw from underneath and
tighten until snug.
tighten until snug.
1" SQ. TUBE
PLASTIC
GUIDE/SPACER
The PULL-OUT LEGREST is now ready to use. However, before using, slide the legrest in and out, and put
the pad up and down to make sure everything works smoothly.
LEGREST
STOWED
SLIDE FORWARD AND INSERT PIN TO LOCK IN "UP" POSITION
SLOT
Copyright © 2018 Aqua Creek Products All Rights Reserved
CHAIR SUPPORT TUBE
PULL OUT LEGREST
PLASTIC GUIDE/SPACER
FLUSH WITH 2" SQ. TUBE
1/4" FLAT WASHER
1/4" LOCK WASHER
1/4" X 1/2" CAP SCREW
LEGREST
OUT
PIN
LEGREST
OUT & UP
3
Revised 2/28/18