aqua living Catalina Luxury Kennedy Hızlı Başlangıç Kılavuzu - Sayfa 5
Sıcak Küvet aqua living Catalina Luxury Kennedy için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. aqua living Catalina Luxury Kennedy 8 sayfaları.
Sayfayı Yazdır
Never turn the GFCI on when the spa is empty.
Always turn the GFCI off when filling the spa or performing maintenance of any kind.
Turning the GFCI on when the spa is empty will immediately damage some components.
Remove the access panel on the same side as the topside controls.
S
Hand tighten the plumbing unions at the heater and pumps.
S
Remove the filter lid & filters.
S
Rinse the acrylic surface & drain water that remains after cleaning.
S
Wipe the surface with a clean, soft cloth.
S
Close the spa drain.
S
Put the water hose in filter housing & begin filling .
S
Check for leaks at the drain & plumbing unions; tighten if necessary.
S
Remove the hose when water level is approximately 1" above the jets..
S
Replace the filters & filter lid.
S
Turn the GFCI on .
S
Refer to the topside control booklet for start-up & user instructions.
S
Replace the cabinet panel & spa cover.
S
S Allow water temperature to reach at least 80°F before adding chemicals.
• Always hand tighten plumbing unions and filters to prevent over tightening.
• Avoid using household cleaners of any kind, which may dull the finish. Never
• The water level varies depending upon the number and size of the bathers.
• Complete instructions to balance your water chemistry begin on page 15 of
www.CatalinaSpas.com
Filling & Refilling
Initial start up & after each cleaning
WARNING! SERIOUS RISK OF DAMAGE!
WARNING!
SERIOUS RISK OF DAMAGE!
use abrasive cloths or cleaners which will scratch the surface.
When you exit the spa, make sure the water level is approximately 1" above
the jets, with exception to neck and shoulder jets. Refer to the Water Level
section on the bottom of page 14 in the owner's manual for additional
information.
the owner's manual.
Luxury Collection 5