Aqua Logic DSHP Series Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 2

Isı Pompası Aqua Logic DSHP Series için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. Aqua Logic DSHP Series 11 sayfaları.

Sayfayı Yazdır

Important: Unpacking your heat pump.

This heat pump was properly packed and accepted by the transportation company

for shipment. It is the responsibility of the transportation company to deliver it to

you in perfect condition.

APPARENT DAMAGE OR LOSS

If, upon delivery, the shipping container or equipment indicates DAMAGE IN

TRANSIT, such damaged goods should not be accepted until the transportation

company's agent has noted on the freight bill, which he will give you, the nature

and extent of the damage. If any part of this shipment is LOST IN TRANSIT, have the

shortage noted on the freight bill by the agent.

CONCEALED DAMAGE

Remove cover to inspect the heat pump for damage.

If, when this equipment is unpacked, shipping damage is discovered which was not

apparent upon delivery, notify the transportation company IMMEDIATELY to

inspect the damaged equipment. The inspector is REQUIRED to provide you with a

DAMAGE INSPECTION report.

THIS INSPECTION MUST BE REQUESTED WITHIN FIFTEEN (15) DAYS OF DELIVERY. DO NOT MOVE DAMAGED SHIPMENTS

FROM POINT OF DELIVERY. RETAIN ALL CONTAINERS AND PACKING FOR INSPECTION.

Protect yourself. File your claim immediately with the transportation company! Remember, Aqua logic Inc. is not

responsible for any damage after the carrier accepts a shipment. Claim for FULL VALUE REIMBURSEMENT should be made

by you against the transportation company. Replacement of the damaged equipment should be requested by the

purchaser as a new order.

THIS DEVICE USES HIGH VOLTAGE ELECTRICAL POWER FOR OPERATION.

CAREFULLY READ AND OBSERVE THE FOLLOWING TO AVOID ELECTRICAL SHOCK

•

We recommend, as with all electrical equipment used in or around water, that you connect your electrical equipment

to a ground-fault interrupt (GFIC) protection circuit.

•

ALWAYS turn the power off for the equipment at the source (circuit breaker) if there is any electrical problem or if the

electrical equipment or controller has been submerged in water.

•

ALWAYS make sure that the electrical circuit you connect your electrical equipment to is rated at least 20% higher than

the maximum current rating on the equipment.

•

ALWAYS make sure that you operate the equipment at the correct voltage.

•

Do NOT attempt to turn off the power at the heat pump or controller if a problem occurs. Disconnect unit at the main

power panel.

Do NOT attempt to repair equipment. Call Aqua Logic for instructions.

WARNING!!!

SAFETY PRECAUTIONS MUST BE OBSERVED.

OR SEVERE DAMAGE TO THE EQUIPMENT.