Aqua Lung Conshelf XIV Kullanıcı Kılavuzu - Sayfa 8

Dalış Aleti Aqua Lung Conshelf XIV için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aqua Lung Conshelf XIV 20 sayfaları.

Attaching the DIN Connector to the Cylinder Valve

1. Unscrew the protector cap from the end of the DIN connector on the first

stage regulator.

2. Remove the protector cap from the cylinder valve.

3. With the cylinder valve facing away from you, release a small amount of air

from the cylinder by turning the handwheel counter-clockwise to open the valve

only slightly. When air is heard exiting, immediately close the valve. This will clear

any moisture or debris that may be inside the threaded cylinder valve opening.

4. Check the condition of the o-ring located in the end of the DIN connector.

5. Position the first stage regulator near the cylinder valve so the MP hose of

the primary second stage will be routed over the right shoulder. Thread the first

stage DIN connector into the cylinder valve by turning the handwheel counter-

clockwise until finger tight. DO NOT use tools to tighten (Fig. 3).

NOTE: The Conshelf XIV does not come standard with a DIN Connector. A

DIN Adapter Kit (PN 107455) is available and can be installed by an Authorized

Aqua Lung Technician.

Conshelf XIV User's Manual

Figure 3