Aqua Lung Conshelf XIV Supreme Kullanıcı Kılavuzu - Sayfa 14

Dalış Aleti Aqua Lung Conshelf XIV Supreme için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aqua Lung Conshelf XIV Supreme 20 sayfaları.

1. Attach the regulator to a charged SCUBA cylinder and open the cylinder

valve to pressurize the regulator. Thoroughly soak both the first and second

stages in a bath of fresh water for at least one hour to loosen and dissolve salt

and mineral deposits.

WARNING:

as this could damage the diaphragm and the internal valve.

2. After the regulator has been properly soaked, it is important to rinse it vigorously

by flushing the main spring cavity of the first stage regulator (non-environmentally

sealed models only), second stage mouthpiece and the openings in the second

stage front cover with a pressurized stream of water. This will remove the deposits

of salt and minerals that were loosened during soaking.

3. Disconnect the regulator as described in the Post-Dive Inspection section of

this manual and wipe it as dry as possible. Hang it by the first stage to ensure

that all the remaining moisture drains from the second stages and accessories.

4. DO NOT leave the regulator exposed to direct sunlight for prolonged periods

of time.

5. When the regulator is completely dry, store it in a clean equipment box or

sealed inside a plastic bag. Do not store it where it may be exposed to extreme

heat or an electric motor, which produces ozone. Prolonged exposure to extreme

heat, ozone, chlorine and ultraviolet rays can cause premature degradation of

the rubber parts and components.

6. When transporting your regulator, take the necessary precautions to ensure

that it is surrounded by a protective cushion to prevent undue shock or impact.

7. Never store the regulator while it is still connected to the cylinder valve.

If you use a garden hose, DO NOT use the high pressure jet

Conshelf XIV User's Manual