ABACO FMC30RF Kullanıcı Kılavuzu - Sayfa 6
Kontrol Ünitesi ABACO FMC30RF için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ABACO FMC30RF 19 sayfaları.
Sayfayı Yazdır
FMC30RF User Manual
4.1 Phycisal specifications
4.1.1 Board Dimensions
The FMC30RF card complies with the FMC standard known as ANSI/VITA 57.1. The card is
a single width conduction cooled mezzanine module (with region 1 and front panel I/O). A
front rib on the carrier hardware is not supported. The stacking height is 10mm.
REF IN
REF OUT
RX CLK
RF IN
RF I/O
TX CLK
4.1.2 Front panel coax inputs
The FMC30RF can be ordered with MMCX or SSMC connector type. Six connectors are
available on the front panel.
4.2 Electrical specifications
The FMC30RF card uses a mix of LVDS and LVCMOS signals. According to the FMC standard
VADJ should be +2.5V to support LVDS, but the FMC30RF is designed to accept any level on
VADJ ranging between 1.65V and 5.5V. VIO_B_M2C connections are connected to VADJ on
the FMC30RF. Level translators are implemented to guarantee VADJ level on the FMC
connector for all single ended communication and control signals.
4.2.1 EEPROM
The FMC30RF card carries a 2Kbit EEPROM (24LC02B) which is accessible from the carrier
2
card through the I
C bus. The EEPROM is powered by 3P3VAUX. The standby current is only
UM015
CDCE
62005
AMC
7823
TRF
3765
TRF
3711
TRF
3720
Figure 2: FMC30RF dimensions
Figure 3: FMC30RF bezel layout
www.abaco.com
AFE
7225
r1.3
- 6 -