DFE STEADYWEB 6 Hızlı Başlangıç Kılavuzu - Sayfa 3
Kontrolör DFE STEADYWEB 6 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. DFE STEADYWEB 6 12 sayfaları. Tension controller
Ayrıca DFE STEADYWEB 6 için: Kullanım Talimatları Kılavuzu (20 sayfalar)
Sayfayı Yazdır
GENERAL DESCRIPTION
The SteadyWeb™6 is a digital tension controller designed to
automatically maintain tension of any continuous material at a
value selected by the equipment operator. The controller
combines ease of use with powerful control features and capability
that allow for effortless configuration and utilization over a wide
variety of tension control applications.
The SteadyWeb™6 can be powered by 24 VDC or with a built-in
100-240 VAC power supply and is available in panel mount and
enclosure mount configurations. The controller is offered in
multiple output versions. The user interface features a context-
sensitive 5" touch screen display. Illustrated prompts and color
graphics make set up easy and allow for a short operator learning
curve.
Basic functions of the controller are divided into three
components: amplifier, tension regulator and output converter.
MOUNTING
Select a mounting location on the machine frame or a wall that will
provide convenient operator interaction and easy screen viewing.
To ensure safety and proper operation, the SteadyWeb™ 6 must
be located away from dusty or wet environments. The unit should
be mounted to a secure wall or surface that can support in excess
of 30 lbs (13.6 kg). As the controller's front panel is hinged to the
bottom of the enclosure, ensure that the mounting location will
allow the front panel to swing open and down unobstructed. In
addition, ensure there will be adequate room below the controller
to allow for wire routing.
INSTALLATION INSTRUCTIONS
Panel Versions
For panel mount units, drill four holes and cut an opening centered
in the holes. Mount your Panel style controller in the hole using
four M3 (#4) nuts and screws.
Enclosure Versions
For enclosure mount units, drill and tap two M4 (#8) holes up from
the desired bottom of the enclosure to match the screw hole
dimensions on the back surface of the SteadyWeb™ 6. The
1