Bilberry Stoves 10kW Stove Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 12
Soba Bilberry Stoves 10kW Stove için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. Bilberry Stoves 10kW Stove 20 sayfaları.
Sayfayı Yazdır
USE WITH WOOD
Lighting:
* Slide the top air control to open and open the spin valve.
* Lay firelighters or rolled up newspapers on the grate with a reasonable quantity, if necessary, of dry kindling,
place 2 or 3 small logs on top.
* Light the newspaper or firelighters using a long taper and close the door.
* When the fire is lighting well, add further logs of a diameter up to 10cms.
* When the stove body is very hot, close the spin valve.
* The burning rate can now be controlled by moving the top air control.
Refuelling:
* Slide the top air control to open, and open spin valve fully.
* Open the door slowly to avoid a sudden rush of air intake, causing smoke to escape into the room and then
refuel.
* Leave the spin valve open for a few minutes to allow the initial volatiles in the wood to burn.
* Close the spin valve.
IMPORTANT: Wood contains a large amount of volatiles which need to be ignited quickly to prevent blow-back.
If the wood just lies smouldering, especially after re-stoking, a lot of smoke is created, which in the worst case
may cause an explosive ignition of the gases resulting in damage to the stove.
In order to ignite the gases that are released from the wood, and to keep clear lasting flames during the com-
bustion process, it is important to let in the required quantity of oxygen (air supply) at all times. The setting of
the air supply, the method of ignition and the lighting intervals depend on the draught in the chimney, the wind
and weather, and amount of heat required, fuel etc.. This means that it may take some time before you get to
know the correct functioning of the stove under any given circumstances.
USE WITH SOLID FUEL
Lighting:
* Slide the top air control to open and open the spin valve.
* Lay firelighters or rolled up newspapers on the grate with a reasonable quantity of dry kindling. Place a small
amount of solid fuel on top.
* Light the newspaper or firelighters using a long taper and close the door.
* When the fire is burning well, add further fuel.
* When the stove body is hot, close the top air control.
* The burning rate can now be adjusted by the spin valve.
Refuelling:
* Open the spin valve fully.
* Open the door slowly to avoid a sudden rush of air intake, causing smoke to escape into the room and then
refuel.
* Leave the spin valve open for a few minutes to allow the initial volatiles in the fuel to burn.
* Adjust the spin valve to the desired position.
12