CP Electronics MWS3A-DD Ürün Kılavuzu - Sayfa 9

Güvenlik Sensörleri CP Electronics MWS3A-DD için çevrimiçi göz atın veya pdf Ürün Kılavuzu indirin. CP Electronics MWS3A-DD 12 sayfaları. Direct dim microwave presence/absence detector
Ayrıca CP Electronics MWS3A-DD için: Kurulum Kılavuzu (20 sayfalar)

Sayfayı Yazdır

10.2 Two channel, individual switches

Functions: Switches both channels with occupancy. Maintains illuminance, dims and switches the

dimming channel using optional single position retractive switch (switch 2). Switches the switching channel

using the optional single position retractive switch (switch 1).

Configured to presence detection: Turns on automatically with occupancy. Maintains illuminance

(dimming channel only). Press and release switch to toggle output. Press and hold switch to dim up and

down (reverses direction with each press). Turns off after occupancy.

Configured to absence detection: Press and release switch to turn on. Maintains illuminance (dimming

channel only). Press and release switch to turn off. Press and hold switch to dim up and down (reverses

direction with each press). Turns off after occupancy.

Channel mode: Set to ―Switch and dim separate‖

Switch mode: Set to ―1 position switch separate‖

PLEASE NOTE THAT THE

DIMMING SIGNAL IS USED TO

SWITCH THE DIMMING

LUMINAIRE ON/OFF AND

THEREFORE THE 240V FEED

TO THE LUMINAIRE FITTING

MUST COME FROM THE

PERMANENT LIVE SUPPLY

NEUTRAL

LIVE

CIRCUIT PROTECTION

(IF REQUIRED)

10.3 Two channel, common switch

Functions: Switches both channels with occupancy. Maintains illuminance, dims and switches the

dimming channel using optional centre biased retractive switch .

Configured to presence detection: Turns on automatically with occupancy. Maintains illuminance

(dimming channel only). Press and release down switch to turn off. Press and release up switch to turn

back on. Press and hold up switch to dim up, press and hold down switch to dim down. Turns off after

occupancy. Channel 1 does not operate with switch.

Configured to absence detection: Press and release up switch to turn on. Maintains illuminance

(dimming channel only). Press and release down switch to turn off. Press and hold up switch to dim up,

press and hold down switch to dim down. Turns off after occupancy. Channel 1 does not operate with

switch.

Channel mode: Set to ―Switch and dim separate‖

Switch mode: Set to ―2 position switch separate‖

DIM-

L/OUT

DIM+

SW1/UP

SW2

DOWN

EBDSPIR-DD SENSOR

MWS3A-DD SENSOR

DIMMING

BALLAST

LUMINAIRE

DIMMING LUMINAIRE

(NON-DIMMING)

(DSI or DALI)

SWITCH 1 - MOMENTARY

PUSH TO MAKE SWITCH

(240V SWITCHING)

Optional for presence,

mandatory for absence detection

SWITCH 2 - MOMENTARY

PUSH TO MAKE SWITCH

(240V SWITCHING)

Optional for presence,

mandatory for absence detection

page 9