Aqua One Cleaview 300 Talimatlar Kılavuzu - Sayfa 7

Evcil Hayvan Bakım Ürünü Aqua One Cleaview 300 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Aqua One Cleaview 300 12 sayfaları.

Maintenance

1 - 2 WEEKS

1. Turn off at the power supply.

2. Remove the dust cover. Slide the carbon

cartridge out of the filter. Allow excess water

to run off. Rinse the cartridge under a high

powered tap to remove the trapped dirt.

3. Tip out dirty water from the filter body. Refill

the filter with aquarium water. Put carbon

cartridge back into position. Turn on at the

power supply.

It is important that the sponge/biogrid is not

cleaned or removed. If it starts to become

extremely dirty, just give them a gentle rinse

in a bucket of aquarium water, then put it back

in position.

6 - 8 WEEKS

1. Turn off at the power supply.

2. Remove entire filter from the back of the

aquarium and take to the sink.

3. Throw away the carbon cartridge and

replace with a new one. Wash the new

cartridge in tap water before use.

4. Remove the entire inlet u-pipe. Grasp the

motor and twist anti clockwise, then gently

pull down to completely remove it from the

filter body.

5. Remove the impeller from the motor and

wash. Use a double ended pipe brush and

clean the impeller well. (Where the impeller

sits).

6. Use an aquarium safe silicon lubricant and

apply to the O-ring seals around the motor.

This will allow easy removal of the motor for

the next service and provide a better water

seal.

7. Put the impeller back in place then reconnect

the motor to the filter body.

8. Clean the inlet u-pipe and extension tube

with a double ended pipe brush then put back

in place.

9. Hang the filter back in place and refill the

filter with aquarium water. Turn filter on at

power supply.

DO NOT CLEAN THE SPONGE/BIOGRID.