Billet Specialties Tru Trac 13125 Kurulum Kılavuzu - Sayfa 4
Motor Billet Specialties Tru Trac 13125 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Billet Specialties Tru Trac 13125 9 sayfaları. Small block chevrolet
Sayfayı Yazdır
3/8-16 x 4" Block Mounting Stud
Figure 1: Install The Block Mounting Studs
Locate and apply RTV silicone sealant to one end of each of the four (4) block mounting
studs and install into the water pump mounting locations. Thread into the block until the
threads are completely seated into the block.
The longer 3/8-16 x 4" block mounting stud is to be installed in the lower passenger side water
pump mounting location.
Tech Tip: Use the two (2) 3/8-16 hex nuts provided as a drive nut by tightening them against
each other, see illustration below.
Use the two 3/8-16 hex nuts as a drive nut to set the studs
6
www.billetspecialties.com • Tech Line 708.588.0505
A
Figure 2: Install Water Pump Spacer & Alternator Bracket
Note: The water pump spacer & alternator bracket incorporate o-rings for sealing. Make sure
to install the four (4) large o-rings for the water pump and the two (2) small o-rings for the
bypass before installing.
A] Install the water pump spacer by sliding the spacer over the block mounting studs.
B] Install the alternator bracket as shown by sliding the bracket over the block mounting
studs on the driver side of the engine.
Small Block Chevrolet Tru Trac - 13225 / 13125
B
7