Billi B-4000 Kullanıcı Kılavuzu - Sayfa 11

Sıhhi Tesisat Ürünleri Billi B-4000 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Billi B-4000 13 sayfaları. Instant boiling and ambient filtered water system
Ayrıca Billi B-4000 için: Kurulum Kılavuzu (8 sayfalar)

Sayfayı Yazdır

User guide

B–4000.

Filter removal and replacement

instructions

1. Remove the front panel, see Diagram 1.

2. Place the unit in Holiday Mode by pressing

the Pressure Relief button once. The lights

on the dispenser will alternate and then go

off, see Diagram 2.

3. Hold filter and swing towards you slowly.

The top of the filter is in a hinged cradle

assembly. It should stop after approximately

30 degrees of travel, see Diagram 3.

4. The filter can now be released from the

holding cradle by pulling down on the filter.

5. Take care not to spill water in the base of the

tray. If so wipe gently with absorbent paper.

6. Install new filter into the same location by

pushing all the way up into the cradle.

7. Push filter back into the unit until it locks

into place. Power light should come back on.

8. Lift ambient lever and run water for 3

minutes.

9. Check for any leaks from around the filter,

hosing or pipeworks.

10. Replace the front cover.